The Educational Irish Research Satellite (EIRSAT-1) is a 2U CubeSat developed at University College Dublin. The project aims to build, test, launch, and operate Ireland’s first satellite and to perform in-orbit demonstrations of three novel payloads developed in-house. To reduce risk within the mission, the project employs a prototype model philosophy in which two models of the spacecraft exist: an engineering qualification model (EQM) and a flight model (FM). This paper presents the verification approach of the functional tests implemented for the EIRSAT-1 project. The activities of the FlatSat and system level full functional tests of the EQM are presented and the results obtained during the test campaigns are discussed. Four test anomalies were encountered during the full functional test campaign resulting in two minor redesigns, and subsequent reassembly, of the CubeSat. The functional test campaigns highlighted the importance of FlatSat level testing of CubeSats to ensure compatibility of all subsystems prior to assembly and of thorough documentation to diagnose any unexpected behaviour of the hardware efficiently. The functional verification of the EQM proved that the system conformed to its design, verifying 57 mission requirements, and is a crucial step towards the development of the EIRSAT-1 FM.
CubeSats facilitate rapid development and deployment of missions for educational, technology demonstration, and scientific purposes. However, they are subject to a high failure rate, with a leading cause being the lack of system-level verification. The Educational Irish Research Satellite (EIRSAT-1) is a CubeSat mission under development in the European Space Agency’s (ESA) Fly Your Satellite! Programme. EIRSAT-1 is a 2U CubeSat with three novel payloads and a bespoke antenna deployment module, which all contribute to the complexity of the project. To increase the likelihood of mission success, a prototype model philosophy is being employed, where both an engineering qualification model (EQM) and a flight model of EIRSAT-1 are being built. Following the assembly of the EQM, the spacecraft underwent a successful full functional test and month-long mission test. An environmental test campaign in ESA Education Office’s CubeSat Support Facility was then conducted with the EQM where both vibration and thermal verification test campaigns were performed. The focus of this paper is the thermal testing and verification of the EIRSAT-1 EQM. Over three weeks, the EQM was subjected to one non-operational cycle, three and a half operational cycles, and a thermal balance test in a thermal vacuum chamber. After dwelling at each temperature extreme, functional tests were performed to investigate the performance of the spacecraft in this space representative environment. The approach to planning and executing the thermal testing is described in detail including the documentation required, set up of the test equipment, and determination of the test levels. Overall, the campaign demonstrated that the mission can successfully operate in a space environment similar to that expected in orbit, despite encountering a number of issues. These issues included a payload displaying anomalous behaviour at cold temperatures and needing to redefine test levels due to an insufficient understanding of the internal dissipation in the spacecraft. A total of two major and three minor non-conformances were raised. Crucially, these issues could not have been found without thermal testing, despite the comprehensive ambient tests performed. The main results and lessons learned during this thermal test campaign are presented with the aim of guiding future missions on optimal approaches in organising and executing the thermal testing of their CubeSats.
Context. More than 60 broad-lined type Ic (Ic-BL) supernovae (SNe) are associated with a long gamma-ray burst (GRB). However, many type Ic-BL SNe exhibit no sign of an associated GRB. On average, the expansion velocities of GRB-associated type Ic-BL SNe (GRB-SNe) are greater than those of type Ic-BL SNe without an associated GRB. It has been proposed that this is the result of energy transfer between the ultra-relativistic GRB jet and the SN ejecta. However, this cannot fully explain the discrepancy, as some type Ic-BL SNe without a GRB detection (ordinary type Ic-BL SNe) may also harbour GRB jets. Aims. This work presents the largest spectroscopic sample of type Ic-BL SNe with and without GRBs to date, consisting of 61 ordinary type Ic-BL SNe and 13 GRB-SNe, comprising a total of 875 spectra. The goal of this work is to compare the evolution of SN expansion velocities in cases where an ultra-relativistic jet has been launched (GRB-SNe) and cases where no GRB jet is inferred from observations (ordinary type Ic-BL SNe). This will help us understand whether the presence of the jet affects the evolution of the expansion velocity, possibly allowing us to infer the existence of jets in cases where GRB emission is not detected. Methods. We measured the expansion velocities of the Fe II [5169 Å] and Si II [6355 Å] features observed in the spectra of type Ic-BL SNe using a spline fitting method. We fit the expansion velocity evolution with single and broken power laws. In each analysis, we compared two populations: ordinary type Ic-BL SNe and GRB-SNe. Results. The expansion velocities of the Fe II and Si II features revealed considerable overlap between the two populations. Although some GRB-SNe expand more rapidly than ordinary type Ic-BL SNe, the difference between the population medians is not statistically significant. Our analysis confirms that type Ic-BL SNe and GRB-SNe generally expand more rapidly than type Ic SNe. The marginalised Fe II and Si II power law indices indicate that GRB-SNe decline at similar rates to ordinary type Ic-BL SNe. Broken power law evolution appears to be more common for the Si II feature, which always follows a shallow-steep decay. In contrast, the broken power law Fe II decays are predominantly steep-shallow. The Si II velocity evolution of PTF12gzk and SN2016coi (engine-driven SNe) are similar to GRB060218-SN2006aj, with both showing broken power law decay. This observation may hint at a two-component ejecta model, such as a GRB jet or a cocoon. Conclusions. Neither the velocities nor their evolution can be used to distinguish between ordinary type Ic-BL SNe and GRB-SNe. Velocities consistent with broken power law evolution may indicate the presence of a GRB jet in some of these ordinary type Ic-BL SNe, but this is likely not as robust as late-time radio surveys. These results suggest that GRB-SNe and ordinary type Ic-BL SNe are drawn from the same underlying population of events.
1 January 2023 in Journal of Astronomical Telescopes, Instruments, and Systems
The capabilities of CubeSats have grown significantly since the first of these small satellites was launched in the early 2000s. These capabilities enable a wide range of mission profiles, with CubeSats emerging as viable platforms for certain space-based astronomical research applications. The Educational Irish Research Satellite (EIRSAT-1) is a CubeSat being developed as part of the European Space Agency’s Fly Your Satellite! program. In addition to its educational aims, the mission is driven by several scientific and technological goals, including goals related to a novel gamma-ray instrument for the detection of bright transient astrophysical sources, such as gamma-ray bursts. This work provides a detailed description of the software development life-cycle for EIRSAT-1, addressing the design, development and testing of robust flight software, aspects of payload interfacing, and risk mitigation. The described design-to-testing approach was implemented to establish, prior to launch, that EIRSAT-1 can perform its intended mission. Constraints and challenges typically experienced by CubeSat teams, which can impact the likelihood of mission success, are considered throughout this work, and lessons learned are discussed. The aim of this work is to highlight the advanced capabilities of CubeSats while providing a useful resource for teams implementing their own flight software.
The compact, standardised form factor of CubeSats allows for the use of commercial off-the-shelf components, reducing traditional barriers to entry, such as cost and development time. More than 1500 of these small spacecraft have been launched in the past 20 years, with improving capabilities that enable a wide range of mission profiles. The Educational Irish Research Satellite, EIRSAT-1, is a CubeSat being developed by a student-led team with goals that span education, technology demonstration and science. A comprehensive mission test plan, in which in-flight conditions are simulated, has been developed for EIRSAT-1 and implemented using an engineering qualification model of the spacecraft. In addition to verifying 41 mission requirements, the successful execution of the mission test plan established that the full satellite system can perform the intended mission. Mission testing also proved to be an invaluable tool to prepare for launch and operations, providing the team with a more complete understanding of the satellite’s expected on-orbit behaviour. This work presents a detailed description of the mission test planning process and implementation, as well as key results and lessons learned. In doing so, this work aims to improve the on-orbit reliability of CubeSats by disseminating resources and good practice around mission testing.