A workflow for the stochastic microstructure modeling of solid oxide cell electrodes is presented. Based on a few real microstructures, the design space can be virtually explored, allowing for a subsequent optimization of microstructure properties.
Peristaltic pump technology is widely used wherever relatively low, highly accurately dosed volumetric flow rates are required and where fluid contamination must be excluded. Thus, typical fields of application include food, pharmaceuticals, medical technology, and analytics. In certain cases, when applied in conjunction with polymer-based tubing material, supplied peristaltic flow rates are reported to be significantly lower than the expected set flow rates. Said flow rate reductions are related to (i) the chosen tube material, (ii) tube material fatigue effects, and (iii) the applied pump frequency. This work presents a fast, dynamic, multiphysics, 1D peristaltic pump solver, which is demonstrated to capture all qualitatively relevant effects in terms of peristaltic flow rate reduction within linear peristaltic pumps. The numerical solver encompasses laminar fluid dynamics, geometric restrictions provided by peristaltic pump operation, as well as viscoelastic tube material properties and tube material fatigue effects. A variety of validation experiments were conducted within this work. The experiments point to the high degree of quantitative accuracy of the novel software and qualify it as the basis for elaborating an a priori drive correction.
11 August 2020 in Biomass Conversion and Biorefinery
Even though biomass gasification remains a promising technology regarding de-centralized sustainable energy supply, its main limitations, namely the issues of unsteady operation, tar formation in after-treatment systems, and consequential high maintenance requirements, have never been fully overcome. In order to tackle the latter two deficiencies and to increase the understanding of thermodynamic and thermokinetic producer gas phase phenomena within the after-treatment zones, a numerical system dynamic model has been created. Thereby, naphthalene has been chosen to represent the behavior of tars. The model has been validated against a wide variety of measured and simulated producer gas compositions. This work particularly focuses on the investigation and minimization of tar formation within after-treatment systems at low pressures and decreasing temperatures. Model-based analysis has led to a range of recommended measures, which could reduce the formation tendency and thus the condensation of tars in those zones. These recommendations are (i) to decrease gas residence time within pipes and producer gas purification devices, (ii) to increase temperatures in low-pressure zones, (iii) to increase hydrogen to carbon ratio, and (iv) to increase oxygen to carbon ratio in the producer gas. Furthermore, the numerical model has been included in the cloud-computing platform KaleidoSim. Thus, a wider range of process parameter combinations could be investigated in reasonable time. Consequentially, a simulation-based sensitivity analysis of producer gas composition with respect to process parameter changes was conducted and the validity basis of the above recommendations was enlarged.