An intensity modulated, continuous-wave (IM-CW) integrated path differential absorption (IPDA) fiber-based lidar is developed herein for measuring atmospheric carbon dioxide (CO2). There are two main challenges in improving measurement accuracy, which have not been given enough attention in the previous research: one is that temperature sensitivity in optical components causes biases, due to the drift of component characteristic, and the other is that speckle noise deteriorates the signal-to-noise ratio. With the components thermally controlled, a target calibration accuracy of 0.003 dB is realized, corresponding to a CO2 concentration precision of better than 1 ppm for a 1 km path. A moving diffuser can reduce speckle noise by time averaging. In this paper, movement of the diffuser is substituted by the perturbation of the emitted laser beam by using a vibrating motor mounted on the optical antenna. Selecting on and off wavelengths with a small wavelength separation can improve the correlation between two laser speckle fields. These improvements result in the improved accuracy of the IPDA lidar system. Finally, the lidar performance was analyzed after the improvements described above were implemented. The diurnal variations of the atmospheric CO2 concentration using a topographic target were performed, and the results showed good agreement with the data measured by an in situ sensor. The root mean square (rms) of the deviation between the IPDA lidar and the in situ sensor was less than 1.4%.
The Mach Zehnder interferometer is an effective device for characterizing coherence of light. By the interference signals of the four channels for the Mach Zehnder interferometer, the interference contrast of Rayleigh Brillouin (RB) backscattering from atmospheric molecules to the laser beam is obtained. This interference contrast is related to the width of the RB backscattering spectrum, which is proportional to the average speed of irregular thermal motion of molecules. This average velocity is directly related to the temperature of the atmosphere at the backscattering point. The interference contrast of RB backscatter at different altitudes can vertically profile temperature. Using a Mach Zehnder interferometer with significant optical path difference, the ultraviolet spaceborne lidar can approach accuracy (random 1 K), vertical resolution (500 m), and horizontal resolution (50 km) of temperature in the troposphere.
Remote sensing of ocean surface pressure from space is very important, and differential absorption LIDAR and differential absorption radar are only two kinds of remote sensing instruments with this potential. The differential absorption LIDAR works with the integral path mode from the spacecraft in the 400 km low-Earth orbit. The differential optical depth of the oxygen A-band is measured, and then the ocean surface pressure is obtained using a circle-iterative calculation. Performance evaluation of the differential absorption LIDAR model was based on feasibility to the advanced system parameters of the space instrument, whilst weak echo pulse energy at ocean surface yielded random errors in the surface pressure measurement. On the other hand, uncertain atmospheric temperature profiles and water vapor mixture profiles resulted in a primary systematic error in the surface pressure. The error of the surface pressure is sensitive to the jitter of the central frequency of laser emission. Under a strict implementation of the error budget, the time resolution is 6.25 s and the along-orbit distance resolution is 44 km, 625 echoes from ocean surface was cumulatively averaged. Consequently, if the jitter of the central frequency of laser emission exceeded 10 MHz, controlling the error of the surface pressure below 0.1% proved almost hopeless; further, the error could be expected to within 0.1–0.2%; however, the error limited within 0.2–0.3% is an achievable indicator.
This paper reviews the WALES mission by the European Space Agency (ESA) and the HALO missions conducted by Langley Research Center (LaRC) of NASA. It evaluates potential risks associated with spaceborne applications by examining factors such as single-pulse energy, pulse repetition frequency, optical frequency stability, efficiency, spectral purity, and reliability. The review also explores advancements in solid-state laser technology operating at 820 nm over the past two decades, as well as recent developments in diode-pumped Er:YAG lasers. Key innovations from these technologies have been incorporated into differential absorption lidar transmitters to enhance performance. Separating weather forecasting from climate-change research is recommended for spaceborne missions. The 935 nm spectral band is optimal for water vapor DIAL measurements in the upper troposphere and lower stratosphere (UTLS). In contrast, the 820 nm band is ideal for measurements in the lower troposphere.