Tayfun Şengül

Dr. Tayfun Şengül

orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 July 2023 in Construction and Building Materials
Verified
Journal Article
Closed access
Tayfun ŞengülTayfun Şengül
Tayfun Şengül
NANoyan Akray
Noyan Akray
YVYasar Vitosoglu
Yasar Vitosoglu

5 January 2017 in Marine Georesources & Geotechnology
Verified
Journal Article
Closed access
Tayfun ŞengülTayfun Şengül
Tayfun Şengül
TETuncer Edil
Tuncer Edil
KOKutay Ozaydin
Kutay Ozaydin
The smear zone, which develops during the placement of the prefabricated vertical drain (PVD) in the ground using a steel mandrel, is a significant factor that influences the performance of PVDs. The determination of the width and hydraulic conductivity of smear zone is an important consideration in designing ground improvement by preloading with PVDs. Thus, the extent and hydraulic conductivity of the PVD smear zone have received significant attention; however, there is still uncertainty and the topic remains discrepant among investigators. There is limited or no smear zone hydraulic conductivity data that is directly produced by laboratory or field tests. In this study, a laboratory smear zone model experiment that was developed as a performance test for determining the extent of the smear zone and measuring directly its hydraulic conductivity was used. Based on the findings obtained from two different materials (Craney Island dredgings and Hydrite R kaolinite soil), it is indicated that the disturbed zone is made up of two areas, namely smear zone and transition zone, and that the hydraulic conductivity in these areas is lower than the undisturbed soil. The ratio of the hydraulic conductivity of the smear and transition zones to that of the undisturbed soil was found to vary between 0.32 and 0.50 and between 0.57 and 0.82, respectively in different soils. The diameter of the smear zone was found to be 2.3–3.3 times higher than the equivalent diameter of the mandrel depending on the soil. The diameter of the transition zone extended 5.2–7.3 times the equivalent diameter of mandrel again depending on the soil. These directly measured values, in general, are supportive of the published values based on indirect means and the test device can be used to study the impact of mandrels of different size and shape and other factors by minor modification.

4 September 2025 in Polymers
Verified
Journal Article
Open access
PDF file
Tayfun ŞengülTayfun Şengül
Tayfun Şengül
YVYaşar Vitoşoğlu
Yaşar Vitoşoğlu
High-plasticity soils pose significant problems in road infrastructure, adversely affecting structural safety due to their unfavorable engineering properties. Lime stabilization is one of the most widely used methods for improving such soils. However, lime addition may cause brittleness of these soils, resulting in a sudden loss of strength. To overcome this weakness, this study investigated using polypropylene fibers in combination with lime stabilization. Accordingly, the plasticity, compressibility, and strength properties of soil mixtures containing 3%, 6%, 9%, and 12% lime, along with mixtures prepared with a constant 0.5% polypropylene fiber content, were systematically evaluated in a laboratory environment. Additionally, the influence of freeze–thaw cycles (FTCs), which induce long-term strength degradation in highway subgrades, on these mixtures was investigated. The results indicated that lime addition reduced the plasticity index by up to 38% without causing a significant change in dry unit weight. It was also determined that FTCs could lead to a strength loss of up to 84% in natural soil, and this loss was substantially reduced by adding lime and fibers. These findings highlight that the lime-fiber combination represents an effective and sustainable method for increasing the performance of high-plasticity soils.

6 August 2024 in Arabian Journal for Science and Engineering
Verified
Journal Article
Open access
PDF file
ABAbdulkadir Bulut
Abdulkadir Bulut
Tayfun ŞengülTayfun Şengül
Tayfun Şengül
Dewatering applications are carried out with geotextile tubes for the disposal or reuse of industrial wastes with high water content. Class F Seyitomer thermal power plant fly ash, an industrial waste, was selected in this study. Turbidity, sedimentation and filtration experiments were carried out using anionic and cationic polymers and polypropylene synthetic fiber to investigate the effect of polymers and fibers on the dewatering of fly ash. The use of polymers was determined to significantly accelerate filtration and soil sedimentation speed while leading to a slight increase in the volume of the filter cake. When effective polymer and dosage are used, slurry filtration time can be reduced up to one-eighth of the time and dewatering can be achieved much faster. The addition of synthetic fiber accelerated the sedimentation of the slurry and increased the filtration in the vertical direction, while it did not show a significant effect on the total filtration in two-dimensional filtration. In geotextile tube applications, although one-dimensional filtration experiments might give misleading results in terms of estimating the effectiveness of the polymers used in solid–liquid separation and dewatering times, the jar test, sedimentation and two-dimensional filtration experiments were determined to give compatible and more realistic results. In two-dimensional filtration experiments, approximately 75% of the filtration occurred in the radial direction and the dewatering time was approximately 21–55% of the time estimated by one-dimensional filtration experiment. Geotextile tube dewatering design can be made more predictable and cost-effective in the field by performing small-scale laboratory experiments with the two-dimensional filtration test system designed for this study and various dewatering applications.

5 May 2014
Verified
Conference Paper
Closed access
DCDogan Cetin
Dogan Cetin
Tayfun ŞengülTayfun Şengül
Tayfun Şengül
MKMahmoud M. Khachan
Mahmoud M. Khachan
SBShobha K. Bhatia
Shobha K. Bhatia
SOSheryl O. Owen
Sheryl O. Owen
Coal-based thermal power plants are the main source of power generation in many industrialized countries. Consequently, management of the considerable quantities of fly ash and other coal combustion residuals is of great importance with wet-storage impoundments being themost common storage option. Although the beneficial reuse of fly ash is increasing worldwide, the problems associated with diminishing impoundments capacities and possible negative impact of fly ash on environment is subsequently becoming a major concern. Legislation is proposed in the US to close or line all existing impoundments. Each of these progressions necessitates an increase in dewatering and transport of wet-disposal fly ash. Recently, geotextile tubes have been used to efficiently and economically dewater a number of low percent-solids sediments, by-products, and wastes. To investigate the effectiveness of geotextile tubes for dewatering hydraulically transported fly ash slurry a number of laboratory studies were conducted. The dewatering behavior of fly ash was evaluated with and without mixing with randomly dispersed waste fibers. The effect of anionic polyacrylamide flocculant on the dewatering performance was also evaluated. Results indicate that geotextile tubes can be effectively used for dewatering flocculated fly ash slurries, and that the strength of retained fly ash can be improved by adding fibers.