In this paper, we describe a new design for a magnetic planetary gearbox. We discuss the theory of operation and a simulated design. We constructed and verified the simulation by measuring the transmitted torque and cogging torque. A magnetic planetary gearbox operates like a mechanical planetary gearbox, except that it is contact-free and needs no gear lubrication. Hence, it has the same characteristics of three transmission modes, a high-speed-reduction ratio, and high durability. The starting point for the design procedure is to avoid possible sliding (i.e., pole-slipping), and we propose three steps to obtain the maximum number of magnetic planet gears. We show that using more planetary gears is a way to increase the transmission torque. Cogging torque can be high in this design. We assessed this potential by using finite-element analysis and then measuring performance of the fabricated gearbox. While the simulation overestimates the cogging torque (for various reasons), we propose a method to reduce the cogging torque to a very low value. We present a literature review to illustrate the development of magnetic gearing and highlight the innovation of this design.
23 July 2003 in Journal of Manufacturing Science and Engineering
This paper presents a predictor-corrector interpolator (PCI) for the CNC machining of parts with parametric curves or surfaces. In contrast to existing parametric interpolators, the proposed method uses a simple algorithm as a predictor and the current feedrate command feedback compensation scheme as the corrector. The predictor adjusts itself according to the current feedrate command feedback, it also has the capability of predicting the next reference point of the parametric curves from the current reference point. As a result, the deviations between the current and desired feedrate commands will always fall within the specified feedrate command tolerances. This study aims at developing the mathematical analysis of the PCI, where the convergence condition is derived for the corrector. In this present approach, the user can specify either constant or variable federate and also its feedrate command accuracy. Both the simulation and experiment results are presented to demonstrate the feasibility of the proposed PCI for machining the parametric curves represented in the Non-Uniform Rational B-Spline (NURBS) form.
Due to the increasing demand of electrical vehicles (EVs), prognostics of the battery state is of paramount importance. The nonlinearity of the signal (e.g. voltage) results in the complexity of analyzing the degradation of the battery. Aging characteristics extracted from the voltage, current, and temperature when the battery is fully charged/discharged were commonly used by previous researchers to determine the battery state. The drawbacks of the previous prediction algorithms are insufficient or irrelevant features to explicitly model the battery aging and the use of fully charged/discharged datasets, which might result in poor prediction accuracy. Therefore, this study proposes a feature selection technique to adequately select optimum statistical feature subset and the use of partial charge/discharge data to determine the battery remaining useful life (RUL) using Recurrent Neural Network - Long Short-Term Memory (RNN-LSTM). The proposed approach demonstrated exceptional RUL prediction results, with the root mean square error (RMSE) of 0.00286 and mean average error (MAE) of 0.00222 using partial discharge data. The proposed method shows prediction improvement in comparison with the use of full data and state-of-the-art outcomes from previous studies of the same open data from the National Aeronautics and Space Administration (NASA) prognostic battery data sets.
30 September 2003 in International Journal of Machine Tools and Manufacture
A robust two degrees of freedom speed controller for a permanent-magnet synchronous motor (PMSM) drive system without using shaft sensor is proposed. The feedback controller and the prefilter are designed in a simple way by extending the utility of the H∞ optimisation procedure. The feedback controller is designed to meet robust stability and disturbance rejection specifications by using the H∞ loop shaping design procedure. For the prefilter the free contractive parameter resulting in H∞ control is used to improve the robust model matching properties of the feedback system. A DSP-based sensorless PMSM drive under the field-oriented control framework is established for experimentally verifying controller performance.