Il Hyuk Ahn

Prof. Dr. Il Hyuk Ahn

mechanical engineering, Tongmyong University, Busan, Republic of Korea

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 October 2019 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
IAIl Hyuk Ahn
Il Hyuk Ahn

21 April 2021 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
ZCZhong Yang Chua
Zhong Yang Chua
SMSeung Ki Moon
Seung Ki Moon
LJLishi Jiao
Lishi Jiao
IAIl Hyuk Ahn
Il Hyuk Ahn

14 September 2022 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Open access
PDF file
SPSeong Jun Park
Seong Jun Park
YSYong Son
Yong Son
IAIl Hyuk Ahn
Il Hyuk Ahn
Owing to the deposition mechanism, parts fabricated from the material extrusion (ME) process have intrinsic air gaps that negatively impact their mechanical properties. Thus, the amount of air gaps should be minimized. In this study, a warm isostatic press (WIP) process was adopted to decrease the amount of air gaps, resulting in improved mechanical properties using acrylonitrile butadiene styrene (ABS). To identify changes in the mechanical properties, tensile tests were performed with specimens heat-treated by the WIP processes with different pressure–temperature profiles. The influence of the temperature and pressure on tensile strength, elongation at break, and toughness was investigated. Water tightness evaluation was conducted to prove the decrease in the air-gap size. Based on the investigation, the WIP process was concluded to be effective for decreasing the intrinsic air gaps and improving the mechanical properties owing to the increase of the bonding force between the lines and layers, which led to the suggestion of a method that optimizes the parameters of the WIP process.

29 November 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
BCByeong-Yeol Choi
Byeong-Yeol Choi
SPSeong Je Park
Seong Je Park
YSYong Son
Yong Son
SHSeung-Jun Han
Seung-Jun Han
HKHyung Giun Kim
Hyung Giun Kim
WCWoo Chun Choi
Woo Chun Choi
Material extrusion (ME) using a filament including metal powders has recently attracted considerable attention because it allows the production of metal parts at low cost. However, like other additive manufacturing processes, metal ME suffers from the problem of internal pores. In this study, warm isostatic pressure (WIP)—a post-process used to downsize or remove the pores in polymer ME—was employed in metal ME to improve the mechanical properties of the finished part. It was confirmed experimentally that the tensile strength and the strain at the ultimate tensile strength were increased by WIP. However, from hardness tests, two different results were obtained. On a microscopic scale, there was no change in hardness because the temperature of the WIP process was not high enough to change the microstructure, while on a macroscopic scale, the hardness changed owing to the collapse of the pores within the material under the indenter load. In specimens with relatively large pores, the hardness sensitivity increases with a larger indenter. Finally, factors affecting the WIP process parameters in metal ME were discussed.