Methyl esters from vegetable oils have attracted a great deal of interest as substitute for petrodiesel to reduce dependence on imported petroleum and provide an alternate and sustainable source for fuel with more benign environmental properties. In the present study biodiesel was prepared from sunflower seed oil by transesterification by alkali-catalyzed methanolysis. The fuel properties of sunflower oil biodiesel were determined and discussed in the light of ASTM D6751 standards for biodiesel. The sunflower oil biodiesel was chemically characterized with analytical techniques like FT-IR, and NMR ((1)H and (13)C). The chemical composition of sunflower oil biodiesel was determined by GC-MS. Various fatty acid methyl esters (FAMEs) were identified by retention time data and verified by mass fragmentation patterns. The percentage conversion of triglycerides to the corresponding methyl esters determined by (1)H NMR was 87.33% which was quite in good agreement with the practically observed yield of 85.1%.
This study describes the chemical speciation of Pb, Zn, Cu, Cr, As, and Sn in soil of former tin mining catchment. Total five sites were selected for sampling and subsequent subsamples were collected from each site in order to create a composite sample for analysis. Samples were analysed by the sequential extraction procedure using optical emission spectrometry (ICP OES). Small amounts of Cu, Cr, and As retrieved from the exchangeable phase, the ready available for biogeochemical cycles in the ecosystem. Low quantities of Cu and As could be taken up by plants in these kind of acidic soils. Zn not detected in the bioavailable forms while Pb is only present in negligible amounts in very few samples. The absence of mobile forms of Pb eliminates the toxic risk both in the trophic chain and its migration downwards the soil profile. The results also indicate that most of the metals have high abundance in residual fraction indicating lithogenic origin and low bioavailability of the metals in the studied soil. The average potential mobility for the metals giving the following order: Sn > Cu > Zn > Pb > Cr > As.
11 February 2013 in Desalination and Water Treatment
Dyes are usually present in trace quantities in the treated effluents of many industries. The effectiveness of adsorption for dye removal from wastewaters has made it an ideal alternative to other expensive treatment methods. Biosorption of acid yellow (AY17), a monoazo acid dye, was investigated using Typha angustata L. as biosorbent in a batch system with respect to initial pH, temperature, initial dye concentration, biosorbent dosage, and contact time. The biomass exhibited the highest dye uptake capacity at 303 K, initial pH value of 2, the initial dye concentration of 150 mg/L, biosorbent dosage of 0.5 g and contact time of 40 min. The extent of dye removal increased with increase in time, biosorbent dosage and decreased with increase in temperature. The equilibrium sorption capacity of the biomass increased on increasing the initial dye concentration up to 150 mg/L and then started decreasing in the studied concentration up to 600 mg/L. The experimental results have shown that the acidic pH favors the biosorption. Langmuir and Freundlich adsorption model is used for the mathematical description of the biosorption equilibrium and isotherm constants are evaluated at different temperatures. Equilibrium data fitted very well to the Freundlich model in the studied concentration (25–600 mg/L) and temperature (303–323 K) ranges. The pseudo-first- and second-order kinetic models were also applied to the experimental data. The results indicated that the dye uptake process followed the pseudo-second-order rate expression and the adsorption rate constants increased with increasing concentration. The adsorption results in this study indicated that all the adsorbents were attractive candidates for removing acidic dyes from dye wastewater.