Jakub Rajewski

Dr. Jakub Rajewski

Nitric Acid Research Group, Łukasiewicz Research Network – New Chemical Syntheses Institute, Puławy, Lubelskie, Poland
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 November 2021 in Membranes
Verified
Journal Article
Open access
PDF file
JRJakub Rajewski
Jakub Rajewski
ADAgnieszka Dobrzyńska-Inger
Agnieszka Dobrzyńska-Inger
In this paper, the response surface methodology (RSM) was proposed for studying the synergistic extraction of chromium(III) ions by double-carrier supported liquid membrane (DCSLM) with organophosphorus carriers (D2EHPA/Cyanex272). At first, the optimization method of “one-factor-at-a-time” was adopted for determination of the best conditions for Cr(III) extraction by SLM with only one carrier (D2EHPA). The optimum/threshold D2EHPA concentration in the membrane phase increased linearly with initial concentration of Cr(III) ions in the feed phase. After the addition the second carrier (Cyanex272), the synergistic effect was observed. The largest percentage of extraction and the shorter time was obtained. The optimization of the synergistic extraction in DCSLM system by RSM using Box–Behnken design (BBD) for three variables (concentration and proportions of the carriers, initial concentration of Cr(III), and time of the process) was studied. The statistical model was verified with the analysis of variance (ANOVA) for the response surface quadratic model. The reduced quadratic model showed that the predicted values were in agreement with those obtained experimentally, as well as the fact that the concentrations and proportions of the carriers had a significant influence on the response. The developed model was considered to be verified and can be used to predict the optimal condition for the chromium ions extraction.

1 June 2016 in Journal of Molecular Liquids
Verified
Journal Article
Closed access
JRJakub Rajewski
Jakub Rajewski
PRPaweł Religa
Paweł Religa

9 March 2019 in Catalysts
Verified
Journal Article
Open access
PDF file
MIMarek Inger
Marek Inger
ADAgnieszka Dobrzyńska-Inger
Agnieszka Dobrzyńska-Inger
JRJakub Rajewski
Jakub Rajewski
MWMarcin Wilk
Marcin Wilk
In this paper, the design of experiments and response surface methodology were proposed to study ammonia oxidation process. The following independent variables were selected: the reactor’s load, the temperature of reaction and the number of catalytic gauzes, whereas ammonia oxidation efficiency and N2O concentration in nitrous gases were assumed as dependent variables (response). Based on the achieved results, statistically significant mathematical models were developed which describe the effect of independent variables on the analysed responses. In case of ammonia oxidation efficiency, its achieved value depends on the reactor’s load and the number of catalytic gauzes, whereas the temperature in the studied range (870–910 °C) has no effect on this dependent variable. The concentration of nitrous oxide in nitrous gases depends on all three parameters. The developed models were used for the multi-criteria optimization with the application of desirability function. Sets of parameters were achieved for which optimization assumptions were met: maximization of ammonia oxidation efficiency and minimization of the N2O amount being formed in the reaction.

1 September 2020 in Catalysts
Verified
Journal Article
Open access
PDF file
MIMarek Inger
Marek Inger
BMBartosz Moszowski
Bartosz Moszowski
MRMonika Ruszak
Monika Ruszak
JRJakub Rajewski
Jakub Rajewski
MWMarcin Wilk
Marcin Wilk
Different variants for abatement of N2O emission from nitric acid plants with the use of catalysts developed at Łukasiewicz-INS were analyzed. Activity tests on a pilot scale confirmed the high activity of the studied catalysts. A two-stage catalytic abatement of N2O emission in nitric acid plants was proposed: by high-temperature decomposition in the nitrous gases stream (HT-deN2O) and low-temperature decomposition in the tail gas stream (LT-deN2O). The selection of the optimal variant for abatement of N2O emission depends on the individual characteristics of the nitric acid plant: ammonia oxidation parameters, construction of ammonia oxidation reactor and temperature of the tail gas upstream of the expansion turbine. It was shown that the combination of both deN2O technologies, taking into account their technological constraints (dimensions of the catalyst bed), allows for a greater abatement of N2O emission, than the use of only one technology. This solution may be economically advantageous regarding the high prices of CO2 emission allowances.

25 March 2019 in Chemical Papers
Verified
Journal Article
Open access
PDF file
MIMarek Inger
Marek Inger
JRJakub Rajewski
Jakub Rajewski
MRMonika Ruszak
Monika Ruszak
MWMarcin Wilk
Marcin Wilk
The supported double-promoted cobalt spinel catalyst has been tested for N2O decomposition in the model and real gas streams (tail gas) from nitric acid plant. Activity tests carried out in the model gas stream showed a high activity of the developed supported catalyst. However, during catalytic investigations performed under real industrial conditions it was found that this catalyst is very sensitive to NOx poisoning. The negative influence of these oxides is visible even at their low concentration. However, the stability tests performed in real nitric acid plant gas streams showed that the developed catalyst preserves its initial activity for at least 40 days. Therefore, the authors propose to apply it in a dual-bed catalytic system consisting of deNOx and deN2O catalyst beds. At the first stage, tail gas is purified from NOx in the NH3-SCR process in the presence of commercial catalyst and at the second stage, catalytic decomposition of N2O into N2 and O2 takes place over the developed supported cobalt spinel catalyst. The deNOx catalyst bed applied in the proposed dual-bed catalytic system allowed for the complete conversion of NOx from the tail gases. After installation of the supported cobalt spinel catalyst downstream of the deNOx catalyst bed, a significant increase in deN2O catalyst activity in the real tail gas stream was observed. Under optimal conditions, this system (F = 150 L/h; T = 425–450 °C) allowed for the complete reduction of N2O emission. It is shown that the proposed catalytic system is robust and allows to obtain high conversions of both NOx and N2O.

6 February 2019 in Journal of Chemistry
Verified
Journal Article
Open access
PDF file
MIMarek Inger
Marek Inger
ADAgnieszka Dobrzyńska-Inger
Agnieszka Dobrzyńska-Inger
JRJakub Rajewski
Jakub Rajewski
MWMarcin Wilk
Marcin Wilk
The design of experiments (DoEs) with response surface methodology (RSM) were used to investigate the effect of operating parameters on the ammonia oxidation process. In this paper, the influence of reactor’s load and temperature of reaction as independent variables was investigated. The efficiency of NH3 oxidation to NO and N2O concentration in nitrous gases gas was identified as response variables. As a result of these studies, statistically significant models for two responses variables were developed.