In this paper, a new control-oriented modeling methodology for the thermal dynamics of water-cooled Proton Exchange Membrane Fuel Cells (PEMFCs) is presented and validated. This methodology is not only useful for control applications, but also can be used for predicting the temperature variation across the stack, allowing to monitor its operation. The methodology has been validated in a real 600-W, 20-cells, water cooled PEMFC, with encouraging results for both the stationary and the transient states. Results show that the proposed methodology is accurate and suitable for control purposes.

This study focuses on the modeling and control optimization of the pitch–roll angles orientation in a quad-rotor UAV (unmanned aerial vehicle) drone system. To address the control challenge, PID (proportional–integral–derivative) controllers are used, which have been tuned through a model-based optimization approach. A non-linear model of the system is obtained and further validated experimentally. The model is implemented in Simulink to conduct model-based optimization. The controller design uses an IMC (internal model control) model-based approach to establish the initial parameters for a PID controller. In the subsequent design phase, a multiobjective approach is taken, incorporating weighted cost functions that account for IAE (integral absolute error) and ITAE (integral of time-weighted absolute error) forms, along with battery usage. The outcomes of this design are showcased through simulations and real-world platform testing.

In the work presented in this paper, data-driven control is used to tune an Internal Model Control. Despite the fact that it may be contradictory to apply a model-free method to a model-based controller, this methodology has been successfully applied to a Activated Sludge Process (ASP) based wastewater treatment. In addition a feedforward controller over the influent substrate concentration was also computed using the virtual reference feedback tuning and applied to the same wastewater process to see the effect over the dissolved oxygen and the substrate concentration at the effluent.