Drag reduction of riblets is one of the most important problems in drag reduction of non-smooth surfaces. In the past two decades, the use of riblets arranged along the flow direction to reduce frictional resistance has received considerable attention. In this paper, we study the plates with the triangular concave grooves, triangular protrusion riblets, trapezoidal concave grooves, trapezoidal protrusion riblets, and circular concave grooves. The numerical simulation method is used to calculate five kinds of plates with grooves and riblets under multiple working conditions. The results showed that the plates with grooves and riblets generated vortices inside the grooves, which separated the incoming flow from the wall surface, and by increasing the thickness of the boundary layer, greatly reducing the average velocity gradient of the wall surface, compared with the smooth flat plate, the friction resistance is reduced. But, lateral riblets and grooves cause additional pressure resistance, which is one order of magnitude higher than the friction resistance. Then, the triangular concave grooves are arranged on the suction and pressure sides of the NACA0012 airfoil, respectively. We calculated the aerodynamic parameters of the both airfoils, and the standard NACA0012 airfoil from the −8° attack angle to their respective stall attack angles. The results showed that the NACA0012 airfoil with triangular concave grooves on the suction side reduced the aerodynamic characteristics of the standard NACA0012 at a small angle of attack, but the stall angle of attack of the standard NACA0012 airfoil was improved, because the grooves ensure that some gas can flow normally on the suction side and delay the separation of the boundary layer. The NACA0012 airfoil with triangular concave grooves on the pressure side did not effectively improve the aerodynamic characteristics: lift–drag ratio decreased and stall angle of attack decreased, but it can increase the lift slightly.
The energy consumption of a vehicle is closely related to the resistance it receives, and it is of great significance to study the drag reduction of a vehicle to promote energy conservation and emissions reductions. Boundary layer control drag reduction is mainly achieved by controlling the coherent structure in turbulence and reducing its burst intensity and frequency. It can be divided into an active control drag reduction and passive control drag reduction. In passive drag reduction, the advantages of the surface groove drag reduction are relatively obvious. In this paper, the large eddy simulation method is used to study the boundary layer flow with triangular groove and rectangular groove plates along the flow direction under subsonic flow, and to explore the influence of a surface micro-groove structure on the boundary layer flow. The simulation results show that the fluid inside the groove can be blocked by the triangular groove which can keep the low-velocity fluid at the bottom of the groove, and that it can increase the thickness of the viscous bottom layer as well as reduce the velocity gradient at the wall. The spanwise stress component of the Reynolds stress in the triangular groove boundary layer and the burst of turbulence on the wall are inhibited, and the spanwise flow in the boundary layer is blocked. In the subsonic range, about 10% shear force can be reduced because there are secondary vortices induced by the upper flow vortices at the top of the groove wall, and these secondary vortices can restrain the rising of the low-speed strip in the groove and reduce the burst of turbulence. The rectangular groove creates a weak blocking effect on the fluid inside the groove, which can only inhibit spanwise pulsation under subsonic speed. The wall shear stress cannot be reduced when the flow velocity is low, and it even increases.