Pipe inspection and maintenance are necessary to prevent economic and casualty losses due to leakage of fluids from damaged pipes. In-pipe soft robots made of highly deformable materials have been proposed to meet the needs, yet most of those comprise multiple segments and require multiple actuators controlled independently, resulting in less compact structures and more demanding control schemes. In this study, we harness the highly nonlinear buckling of elastic ribbons and bioinspired artificial muscles to significantly enhance the crawling capability of a single-actuator soft robot. Our prototype robot consists of a McKibben pneumatic actuator surrounded by three longitudinally arranged elastic ribbons. These tailored ribbons are three-dimensional (3D) printed and can be buckled into highly deformed 3D shapes upon inflation of the actuator. First, we show that the robot exhibits strong anisotropic friction when fully buckled. Then, we demonstrate that by simple open-loop on/off control, our robot achieves robust crawling in horizontal, vertical, bent pipes and even wet pipes partially or filled with water. It can also adapt to pipes with some variations in diameter. Using only one actuator lowers the complexity of robot structure and pneumatic system, offering high potential for new applications at different scales.
Flying height (FH) control sliders with thermal actuation have been introduced recently in commercial products for compensating the static FH loss and reducing the risk of head-disk contacts. In the research reported here, we investigated the effects of air-bearing surface (ABS) designs on the thermal actuation. We created a three-dimensional finite element model of an entire slider with a detailed read/write transducer structure and conducted thermal-structural coupled-field analysis using velocity slip and temperature jump boundary conditions to formulate the heat transfer across the head-disk interface when a slider flies over a spinning disk. An iteration procedure was used to obtain the equilibrium solutions. Four ABS designs with distinct features were simulated. We defined five measures of merit, including protrusion rate, actuation efficiency, power consumption, pressure peak, and temperature rise of the sensor to evaluate the performance of thermal actuation. It is found that the effect of the pressure is more significant than that of the FH on the heat conduction from the slider to the disk. The efficiencies of three conventional designs decrease as the FHs are continuously reduced. A new ABS design, called “Scorpion III,” is presented and demonstrates an overall enhancement, including virtually 100% efficiency with significantly less power consumption. Transient thermal analysis showed that it requires for the temperature to reach the steady-state values, and there is a trade-off between increasing the actuation bandwidth and decreasing the power consumption.
To achieve the areal density goal in hard disk drives of 1 Tb/in/sup 2/ the minimum physical spacing or flying height (FH) between the read/write transducer and disk must be reduced to about 2 nm. At such low spacing new nanoscale forces act between the slider and disk, such as intermolecular and electrostatic forces, which must be taken into consideration in the air bearing design. These forces increase the level of flying height modulations (FHMs), which in turn creates dynamic instability and intermittent contact in the flying head slider similar to what has been observed in experiments. Here, we present three possible approaches to minimize such forces and/or reduce FHM by FH control, including a micro-trailing pad slider, a thermal flying height control slider, and a piezoelectric flying height control slider for hard disk drives.
We studied highly L10-ordered FePtAg–C nanogranular film as a potential high-density storage medium in thermally assisted magnetic recording (TAR). A 6.4-nm-thick FePtAg–C film with a perpendicular coercivity of 37 kOe and an average grain size of 6.1±1.8 nm was fabricated on oxidized silicon substrate with a 10 nm MgO interlayer at 450 °C. The time-dependence measurement of remnant coercivity showed the energy barrier of Eb = 7.6 eV ∼300 kBT at room temperature, meaning the excellent thermal stability for long-term data storage. Static tester experiments on this film using a TAR head demonstrate the feasibility of recording at an areal density of ∼450 Gbits/in.2.