Based on the important effect of catalysts on the plasma-catalytic system, the CM/Z5 catalyst prepared by the incipient-wetness impregnation method is used for non-thermal plasma catalysis for toluene removal. The low-temperature plasma used is produced by dielectric barrier discharge. Toluene removal performance with single plasma is investigated by variation in experimental parameters. Results indicate that with the increase in discharge length, the selectivity of carbon dioxide increased. With the increase in toluene concentration and gas flow rate, carbon dioxide selectivity decreases gradually, while toluene conversion shows almost no difference. With the introduction of CM/Z5 catalyst into the back end of plasma, the toluene conversion rate and carbon dioxide selectivity could be significantly improved and ozone in the exhaust gas could be eliminated to meet emission standards at the same time. This work is meaningful in promoting the industrial application of plasma catalytic coupling technology to treat volatile organic compounds.
Although biodiesel-diesel blends are being widely used in diesel engines, investigations on its cold flow properties and crystallization behavior are still scarce. In this paper, poly(ethylene-vinyl acetate) (PEVA) pour point depressant and petroleum diesel were worked together to enhance the cold flow properties of soybean biodiesel. PEVA presented a better positive effect in reducing the cold filter plugging point (CFPP) of biodiesel blends. B40 treated with 1% PEVA exerted the best cold flow properties, and its CFPP was decreased by -14 °C. In addition, the crystallization behavior was changed variously. The sizes of crystals were decreased as well as the number of crystals was increased notably.
1 January 2020 in Chinese Journal of Organic Chemistry
Although biodiesel-diesel blends are being widely used in diesel engines, investigations on its cold flow properties and crystallization behavior are still scarce. In this paper, poly(ethylene–vinyl acetate) (PEVA) pour point depressant and petroleum diesel were worked together to enhance the cold flow properties of soybean biodiesel. PEVA presented a better positive effect in reducing the cold filter plugging point (CFPP) of biodiesel blends. B40 treated with 1% PEVA exerted the best cold flow properties, and its CFPP was decreased by −14 °C. In addition, the crystallization behavior was changed variously. The sizes of crystals were decreased as well as the number of crystals was increased notably.
The effects of Ce incorporation into trimetallic PtSnIn-supported catalysts were investigated for a propane dehydrogenation reaction with advanced characterization techniques. It was found that some Ce species exist in the form of CeAlO3 on the reduced PtSnIn/xCe-Al catalyst, significantly enhancing the thermal stability of the alumina support. The NH3-TPD measurements verified that the total acidity of the PtSnIn/xCe-Al catalysts decreases with the addition of Ce. The PtSnIn/1.5Ce-Al catalyst exhibits the optimal particle distribution with the smallest Pt particle size of 8.0 nm, which was revealed by TEM. The H2-TPR and XPS results suggest that more oxidized-state Sn species form on catalyst surfaces, and the metal–support interaction can be strengthened when Ce is introduced. Furthermore, TG analysis demonstrates that Ce incorporation substantially reduces coke formation on the spent catalysts. The PtSnIn/1.5Ce-Al catalyst exhibits exceptional catalytic performance, achieving an initial propane conversion of 62.6% and maintaining a conversion of 57.2% after a 120 min reaction. In addition, the PtSnIn/1.5Ce-Al catalyst possesses high long-term stability. Over 40.0% propane conversion can be maintained after a 53 h continuous PDH reaction. These findings highlight the pivotal role of Ce in improving the structural properties and catalytic performance of PtSnIn-based catalysts for propane dehydrogenation, offering valuable insights for the design of highly efficient and stable dehydrogenation catalysts.