To improve the low dispersibility of rGO, solvothermal reduction was applied with N , N -dimethylformamide and the electrochemical performance was measured.
Since microplastics are considered harmful to the human body, studies on their samplings, pretreatments and analyses environmental media, such as water, are continuously being conducted. However, a standard sampling and pretreatment method must be established, particularly because microplastics of a few micrometers in size are easily affected by external contamination. In this study, a microplastic sampling device was designed and developed to obtain a high recovery rate of microplastics and prevent plastics contamination during all processes. For the evaluation of the developed device, microplastic reference materials were produced and used, and computational fluid dynamics (CFD) analysis was performed. This device has not only been applied to the relatively large previously studied microplastics (100 µm) but also to microplastics of approximately 20 µm that are vulnerable to contamination. A recovery rate of 94.2% was obtained using this device, and the particles were separated by filtration through a three-stage cassette. In conclusion, we propose a method to increase the accuracy and reproducibility of results for microplastic contamination in the environment. This method is able to consistently obtain and manage microplastics data, which are often difficult to compare using various existing methods.
Correction for ‘Evaluating the dispersibility of rGO prepared using a solvothermal method with DMF and its application as a CDI electrode material: recovery of sp2-hybridized carbon’ by Junho Lee et al., RSC Adv., 2024, 14, 22665–22675, https://doi.org/10.1039/D4RA03387F.
Anion exchange membrane water electrolysis (AEMWE) is a promising platform for sustainable hydrogen production because it enables the use of non-noble metal catalysts in alkaline environments. However, conventional carbon-based anodes are prone to corrosion and structural degradation under oxidizing conditions, hindering the development of durable and active anode catalysts. To address this limitation, a graphene framework was employed as the anode, with iridium- and nickel-based single-atom catalysts (SACs) stabilizing the active sites and tailoring the interfacial environments. The impact of atomic anchoring sites, i.e., graphene edges versus basal planes, on catalytic performance and durability of the anode was examined. To deliberately control the anchoring preference of metal atoms, a post-calcination air-injection procedure is introduced, inducing moderate surface hydroxylation and stabilizing single-atom configurations on graphene. Advanced characterizations (high-angle annular dark-field scanning transmission electron microscopy, X-ray photoelectron spectroscopy, and extended X-ray absorption fine structure) reveal that iridium atoms preferentially anchor at the hydroxyl-group-rich graphene edges. In contrast, nickel atoms incorporate into the basal-plane carbon or nitrogen coordination sites. Edge-anchored iridium SACs demonstrate higher oxygen evolution activity but lower stability, whereas basal-anchored nickel SACs exhibit improved durability at the expense of catalytic activity. These findings establish a structure–property relationship between atomic coordination and electrochemical behavior, providing a design principle for graphene-based anode catalysts that can simultaneously enhance durability and reduce the cost of hydrogen production.