Juan Monzó-Cabrera

Dr. Juan Monzó-Cabrera

Universidad Politécnica de Cartagena
orcid

Research Focus & Metrics

Academic Career Length

27Years (2000-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 May 2005 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
PPP. Plaza-Gonzalez
P. Plaza-Gonzalez
Juan Monzó-CabreraJuan Monzó-Cabrera
Juan Monzó-Cabrera
JCJOSE MANUEL CATALA CIVERA
JOSE MANUEL CATALA CIVERA
DSD. Sanchez-Hernandez
D. Sanchez-Hernandez
In this paper, several mode-stirrer configurations are compared in order to establish their influence on the electric-field uniformity within an irradiated dielectric sample inserted in a microwave-heating applicator. Two different scenarios are evaluated with metallic sheets moving inside the multimode applicator. The different stirrer configurations are tested and compared for low-, medium-, and high-loss dielectric sample materials. Additionally, a straightforward procedure based on a generalized plane-wave approach is proposed and evaluated as a computationally efficient alternative for calculating the electric-field distribution inside materials processed in these microwave applicators with mode stirrers. Although very different electric patterns are achieved depending on stirrer geometry and sample permittivity, the plane-wave approach has been shown to provide a very good approximation for medium and high lossy dielectric materials.

11 March 2013 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
Alejandro Martínez RosAlejandro Martínez Ros
Alejandro Martínez Ros
JGJosea Luis Gomez-Tornero
Josea Luis Gomez-Tornero
FCFrancisco Javier Clemente-Fernandez
Francisco Javier Clemente-Fernandez
Juan Monzó-CabreraJuan Monzó-Cabrera
Juan Monzó-Cabrera
The possibility of microwave near-field focusing using a simple width-tapered microstrip leaky-wave antenna is theoretically and experimentally proven in this paper. The design procedure to obtain the modulation of the microstrip width along the antenna length is described, illustrating the conditions and limitations for optimum focusing at a certain focal point and using a given substrate. A 7.5 λ0 -long microstrip lens is designed to operate at 15 GHz, and its focusing properties are studied. An array of two in-phase microstrip lenses located front-to-front is proposed to obtain a symmetric focusing pattern with higher spatial resolution. Theoretical and experimental results demonstrate the optimum synthesis of a focusing region with focal length of 3 λ0, presenting focal width of only 0.33 λ0 , and focal depth of 1.25 λ0. Finally, it is reported the frequency focus-scanning performance in the range 14-17 GHz. All these features make the proposed microstrip lens a simpler alternative solution to focused planar phased-arrays.

18 May 2004 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
PPP. Plaza-Gonzalez
P. Plaza-Gonzalez
Juan Monzó-CabreraJuan Monzó-Cabrera
Juan Monzó-Cabrera
JCJOSE MANUEL CATALA CIVERA
JOSE MANUEL CATALA CIVERA
DSD. Sanchez-Hernandez
D. Sanchez-Hernandez
We present a new approach for inferring the electric field distribution inside materials in multimode cavities with mode stirrers. We calculate the electric field in the dielectric material by a two-dimensional modeling of a typical multimode microwave applicator with some mobile metallic sheets. We compare simulated results with classical approaches, such as Lambert's law or a constant electric field distribution. The proposed method allows for a better understanding of how these structures can be applied for heating materials when computing the microwave energy absorption in the dielectric. Finally, we perform experimental tests in a microwave multimode oven for validating purposes.

15 January 2007 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
EDElsa Dominguez-Tortajada
Elsa Dominguez-Tortajada
Juan Monzó-CabreraJuan Monzó-Cabrera
Juan Monzó-Cabrera
Alejandro Diaz-MorcilloAlejandro Diaz-Morcillo
Alejandro Diaz-Morcillo
In this paper, the design of a dielectric multilayer around a clay sample is presented to achieve a uniform electric field distribution over that sample. This structure is located within a multimode microwave-heating oven and is designed by means of genetic algorithms. The permittivity and geometric values for the sample surrounding layers are the selected parameters to be optimized in order to minimize the ratio between the typical deviation and the absolute value of the electric field. The results demonstrate the improvement of the electric field uniformity over the sample using dielectric layers

14 May 2024 in Physical Review D
Verified
Journal Article
Open access
PDF file
PNPablo Navarro
Pablo Navarro
BMBenito Gimeno Martinez
Benito Gimeno Martinez
Juan Monzó-CabreraJuan Monzó-Cabrera
Juan Monzó-Cabrera
Alejandro Diaz-MorcilloAlejandro Diaz-Morcillo
Alejandro Diaz-Morcillo
DBDiego Blas
Diego Blas
The direct detection of gravitational waves (GWs) of frequencies above MHz has recently received considerable attention. In this work, we present a precise study of the reach of a cubic cavity resonator to GWs in the microwave range, using for the first time tools allowing to perform realistic simulations. Concretely, the boundary integral—resonant mode expansion (BI-RME) 3D method, which allows us to obtain not only the detected power but also the detected voltage (magnitude and phase), is used here. After analyzing three cubic cavities for different frequencies and working simultaneously with three different degenerate modes at each cavity, we conclude that the sensitivity of the experiment is strongly dependent on the polarization and incidence angle of the GW. The presented experiment can reach sensitivities up to 1×10−19 at 100 MHz, 2×10−20 at 1 GHz, and 6×10−19 at 10 GHz for optimal angles and polarizations, and where in all cases we assumed an integration time of Δt=1  ms. These results provide a strong case for further developing the use of cavities to detect GWs. Moreover, the possibility of analyzing the detected voltage (magnitude and phase) opens a new interferometric detection scheme based on the combination of the detected signals from multiple cavities.

18 November 2008 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
Juan Monzó-CabreraJuan Monzó-Cabrera
Juan Monzó-Cabrera
JPJuan L. Pedreno-Molina
Juan L. Pedreno-Molina
Antonio José LozanoAntonio José Lozano
Antonio José Lozano
ATAna Toledo
Ana Toledo
In this study, a novel ten-port waveguide microwave sensor is designed, implemented, calibrated and tested in order to obtain the reflection coefficient magnitude and phase. This reflectometer is based on the well known six-port structure but the number of detectors has been increased to eight in order to improve the sampling procedure of the standing wave present within the waveguide. In addition, a learning method based on neural networks' usage has been implemented for autonomous calibration from the data collected by a vector network analyzer. An automated procedure consisting of a moving sample within a multimode cavity has enabled different reflection coefficients to be obtained. Neural networks have been employed in order to learn the relationship between the actual reflection parameter and the acquired signals from eight power detectors. This novel device has been calibrated with a neural architecture based on radial basis functions and the error of device measurements has been analyzed. This new design and the incorporated neural network calibration allow one to avoid problems caused by fault or nonlinearity of the detectors, and to get robustness, flexibility and adaptability characteristics for the presented device.