In this review, we examine opportunities and challenges for 21st-century robotic agricultural cotton harvesting research and commercial development. The paper reviews opportunities present in the agricultural robotics industry, and a detailed analysis is conducted for the cotton harvesting robot industry. The review is divided into four sections: (1) general agricultural robotic operations, where we check the current robotic technologies in agriculture; (2) opportunities and advances in related robotic harvesting fields, which is focused on investigating robotic harvesting technologies; (3) status and progress in cotton harvesting robot research, which concentrates on the current research and technology development in cotton harvesting robots; and (4) challenges in commercial deployment of agricultural robots, where challenges to commercializing and using these robots are reviewed. Conclusions are drawn about cotton harvesting robot research and the potential of multipurpose robotic operations in general. The development of multipurpose robots that can do multiple operations on different crops to increase the value of the robots is discussed. In each of the sections except the conclusion, the analysis is divided into four robotic system categories; mobility and steering, sensing and localization, path planning, and robotic manipulation.

Using artificial intelligence (AI) and the IoT (Internet of Things) is a primary focus of applied engineering research to improve agricultural efficiency. This review paper summarizes the engagement of artificial intelligence models and IoT techniques in detecting, classifying, and counting cotton insect pests and corresponding beneficial insects. The effectiveness and limitations of AI and IoT techniques in various cotton agricultural settings were comprehensively reviewed. This review indicates that insects can be detected with an accuracy of between 70 and 98% using camera/microphone sensors and enhanced deep learning algorithms. However, despite the numerous pests and beneficial insects, only a few species were targeted for detection and classification by AI and IoT systems. Not surprisingly, due to the challenges of identifying immature and predatory insects, few studies have designed systems to detect and characterize them. The location of the insects, sufficient data size, concentrated insects on the image, and similarity in species appearance are major obstacles when implementing AI. Similarly, IoT is constrained by a lack of effective field distance between sensors when targeting insects according to their estimated population size. Based on this study, the number of pest species monitored by AI and IoT technologies should be increased while improving the system’s detection accuracy.

Automation continues to play a greater role in agricultural production with commercial systems now available for machine vision identification of weeds and other pests, autonomous weed control, and robotic harvesters for fruits and vegetables. The growing availability of autonomous machines in agriculture indicates that there are opportunities to increase automation in cotton production. This article considers how current and future advances in automation has, could, or will impact cotton production practices. The results are organized to follow the cotton production process from land preparation to planting to within season management through harvesting and ginning. For each step, current and potential opportunities to automate processes are discussed. Specific examples include advances in automated weed control and progress made in the use of robotic systems for cotton harvesting.

This study proposes an algorithm that controls an autonomous, multi-purpose, center-articulated hydrostatic transmission rover to navigate along crop rows. This multi-purpose rover (MPR) is being developed to harvest undefoliated cotton to expand the harvest window to up to 50 days. The rover would harvest cotton in teams by performing several passes as the bolls become ready to harvest. We propose that a small robot could make cotton production more profitable for farmers and more accessible to owners of smaller plots of land who cannot afford large tractors and harvesting equipment. The rover was localized with a low-cost Real-Time Kinematic Global Navigation Satellite System (RTK-GNSS), encoders, and Inertial Measurement Unit (IMU)s for heading. Robot Operating System (ROS)-based software was developed to harness the sensor information, localize the rover, and execute path following controls. To test the localization and modified pure-pursuit path-following controls, first, GNSS waypoints were obtained by manually steering the rover over the rows followed by the rover autonomously driving over the rows. The results showed that the robot achieved a mean absolute error (MAE) of 0.04 m, 0.06 m, and 0.09 m for the first, second and third passes of the experiment, respectively. The robot achieved an MAE of 0.06 m. When turning at the end of the row, the MAE from the RTK-GNSS-generated path was 0.24 m. The turning errors were acceptable for the open field at the end of the row. Errors while driving down the row did damage the plants by moving close to the plants’ stems, and these errors likely would not impede operations designed for the MPR. Therefore, the designed rover and control algorithms are good and can be used for cotton harvesting operations.

In Tanzania, agriculture sector is known for employing more than 70% of the total population. Agriculture sector faces many challenges including climate change. Climate change causes low productivity in agriculture; low productivity is caused due to poor implementation of agricultural policies and strategies. This poor implementation of policies has also caused many farmers to be not competent in climate change adaptation. Over the years, provisions of agricultural advice and extension were provided by various approaches, including training and visit extension, participatory approaches, and farmers’ field schools. However, provision of agricultural advisory and extension service is inefficient. Also, in most cases the usage of most agricultural innovations and technologies developed is limited. A literature review indicates that the main reasons given by Tanzanian farmers for not using improved technology are not lack of knowledge or skill, but rather that the technologies do not contribute towards improvements (e.g., the technologies are not profitable or they imply to high risk). Thus, agricultural extension service needs to be geared towards teaching farmers how to develop innovative and cost effective technologies that are contextualized. Limited numbers of agricultural extension staff and less interactivity of Information and Communication Technologies (ICTs), such as radio and television, have been mentioned to be among the factors limiting the provision of agricultural advisory and extension services to the majority of farmers in Tanzania. The advancements in ICTs have brought new opportunities for enhancing access to agricultural advisory and extension service for climate change adaptation. In Tanzania, farmers and other actors access agricultural information from various sources such as agricultural extension workers and use of various databases from Internet Services Providers. Also there are different web – and mobile – based farmers’ advisory information systems to support conventional agricultural extension service. These systems are producing bulk amounts of data which makes it difficult for different stakeholders to make an informed decision after data analysis. This calls for the need to develop a tool for data visualization in order to understand hidden patterns from massive data. In this study, a semi-automated text classification was developed to determine the frequently asked keywords from a web and mobile based farmers’ advisory system called UshauriKilimo after being in use for more than 2 years by more than 700 farmers.