With the increasingly obvious DC characteristics at both ends of the source and load sides of the low-voltage distribution network, the application scenarios of low-voltage DC microgrid gradually appear. Compared with the AC system, the DC microgrid has the characteristics of low inertia, weak damping, and poor anti-disturbance capabilities, all of which are important for improving operational stability. A virtual inertia adaptive control approach for fast-tracking energy storage under varied disturbances is presented using energy storage as a virtual inertia unit. Firstly, a stability analysis model including constant power load is constructed for the low-voltage DC microgrid; then, the control logic of the virtual inertia of the energy storage system is designed. Finally, the corresponding model is built in MATLAB/SIMULINK and the experiment platform to verify the correctness and effectiveness of the proposed control strategy.
With the large amounts of small capacity and heterogeneous distributed electricity units connected to the distribution power network, there exist increasingly complex management challenges. In this paper, a new management scheme that can classify and divide the distributed units according to their adjustable characteristics is proposed, which consequently forms an effective collection of fragmented adjustable ability and promotes the utilization of micropower resources. Inspired by the social division of labor in the biological community, the approach is based on a logical aggregation with the division of labor. A feature extraction method was acquired on the basis of the daily output curve, which reduces the data dimension and, subsequently, clusters the output feature points by the K-means algorithm. The simulation is performed by taking the measured output curve of low voltage distributed units on the low voltage side. The experimental results analyze the characteristics of seven classes of distributed units, allocate two main features, and reorganize them into a cluster; so, the “5-dimensional feature array” is reduced to “2-dimensional feature points”. The results demonstrate that the proposed cluster method can enable the power grid to identify and classify the distributed units automatically.