In this study, a mass-conserving multiphase lattice Boltzmann (LB) model is proposed for simulating the multiphase flows. The proposed model developed in the present study is to improve the model of Shao et al. [“Free-energy-based lattice Boltzmann model for simulation of multiphase flows with density contrast,” Phys. Rev. E 89, 033309 (2014)] by introducing a mass correction term in the lattice Boltzmann model for the interface. The model of Shao et al. [(the improved Zheng-Shu-Chew (Z-S-C model)] correctly considers the effect of the local density variation in momentum equation and has an obvious improvement over the Zheng-Shu-Chew (Z-S-C) model [“A lattice Boltzmann model for multiphase flows with large density ratio,” J. Comput. Phys. 218(1), 353–371 (2006)] in terms of solution accuracy. However, due to the physical diffusion and numerical dissipation, the total mass of each fluid phase cannot be conserved correctly. To solve this problem, a mass correction term, which is similar to the one proposed by Wang et al. [“A mass-conserved diffuse interface method and its application for incompressible multiphase flows with large density ratio,” J. Comput. Phys. 290, 336–351 (2015)], is introduced into the lattice Boltzmann equation for the interface to compensate the mass losses or offset the mass increase. Meanwhile, to implement the wetting boundary condition and the contact angle, a geometric formulation and a local force are incorporated into the present mass-conserving LB model. The proposed model is validated by verifying the Laplace law, simulating both one and two aligned droplets splashing onto a liquid film, droplets standing on an ideal wall, droplets with different wettability splashing onto smooth wax, and bubbles rising under buoyancy. Numerical results show that the proposed model can correctly simulate multiphase flows. It was found that the mass is well-conserved in all cases considered by the model developed in the present study. The developed model has been found to perform better than the improved Z-S-C model in this aspect.

In the present study, the magnetic field induced self-assembly processes of magnetic microparticles in an aqueous liquid (the pure magnetic fluid) and nonmagnetic microparticles in ferrofluid (the inverse magnetic fluid) are experimentally investigated. The microparticles are formed into chain-like microstructures in both the pure magnetic fluid and the inverse magnetic fluid by applying the external magnetic field. The fluorescence parameters of these self-assembled chain-like microstructures are measured and compared to those without the effect of magnetic field. It is found that the fluorescence in the pure magnetic fluid is weakened, because the scattering and illuminating areas are reduced in the microstructures. On the contrary, the fluorescence in the inverse magnetic fluid is enhanced, because more fluorescent nonmagnetic microparticles are enriched and become detectable under the effect of the magnetic dipole force and the magnetic levitational force, and their unnecessary scattering can be absorbed by the surrounding ferrofluid. The average enhancement of the fluorescence area ratio in the inverse magnetic fluid with 3 μm nonmagnetic microparticles reaches 112.92%. The present work shows that the inverse magnetic fluid has advantages such as low cost, no scattering effect, stable fluorescence intensity, and relatively low magnetic resistance. In the end, a prototype design for the novel detection of coronavirus disease 2019 based on the magnetic field induced self-assembly in the inverse magnetic fluid is proposed, which could support the epidemic prevention and control.

In the present study, a fractional-step-based multiphase lattice Boltzmann (LB) method coupled with a solution of a magnetic field evolution is developed to predict the interface behavior in magnetic multiphase flows. The incompressible Navier–Stokes equations are utilized for the flow field, while the Cahn–Hilliard equation is adopted to track the interface, and these governing equations are solved by reconstructing solutions within the LB framework with the prediction–correction step based on a fractional-step method. The proposed numerical model inherits the excellent performance of kinetic theory from the LB method and integrates the good numerical stability from the fractional-step method. Meanwhile, the macroscopic variables can be simply and directly calculated by the equilibrium distribution functions, which saves the virtual memories and simplifies the computational process. The proposed numerical model is validated by simulating two problems, i.e., a bubble rising with a density ratio of 1000 and a viscosity ratio of 100 and a stationary circular cylinder under an external uniform magnetic field. The interfacial deformations of a ferrofluid droplet in organic oil and an aqueous droplet in ferrofluid under the external magnetic field are, then, simulated, and the underlying mechanisms are discussed. Moreover, the rising process of a gas bubble in the ferrofluid is investigated, which shows that the rising velocity is accelerated under the effect of the external magnetic field. All the numerical examples demonstrate the capability of the present numerical method to handle the problem with the interfacial deformation in magnetic multiphase flows.