Purpose: The purpose of this paper is to develop identification system for fiber optic connectors in passive distribution cabinets. The system should have alternative power supply and wireless communication unlike the identification systems commercially available, which will make the system fully autonomous. Design/methodology/approach: Detailed project and realization of real demonstrator of fully autonomous identification system. After the realization of the demonstrator, its optimization was performed. Findings: It is possible to build fully autonomous identification system which requires 15.6 mJ energy to perform one cycle of identification process. Moreover, it is possible to use the alternative power method to supply this system. Originality/value: Fully autonomous identification system of fiber optic connectors with alternative power supply and wireless communication.
1 April 2016 in Journal of Physics: Conference Series
A huge progress of down-sizing technology together with trend of decreasing power consumption and, on the other hand, increasing efficiency of electronics give the opportunity to design and to implement the energy harvesters as main power sources. This paper refers to the energy that can be harvested from electromagnetic field in the unlicensed frequency bands. The paper contains description of the most popular techniques and transducers that can be applied in energy harvesting domain. The overview of current research and commercial solutions was performed for bands in ultra-high frequency range, which are unlicensed and where transmission is not limited by administrative arrangements. During the experiments with Powercast's receiver, the same bands as sources of electromagnetic field were taken into account. This power source is used for conducting radio-communication process and excess energy could be used for powering the extra electronic circuits. The paper presents elaborated prototype of energy harvesting system and the measurements of power harvested in ultra-high frequency range. The evaluation of RF energy harvesters for powering ultra-low power (ULP) electronic devices was performed based on survey and results of the experiments.
1 April 2016 in Journal of Physics: Conference Series
Fiber Distribution Cabinets (FDC) monitoring systems are increasingly popular. However it is difficult to realize such system in passive FDC, due to lack of source of power supply. In this paper investigation of four different DC power supplies with optoelectronic transducers is described. Two converters: photovoltaic power converter and PIN photodiode can convert the light transmitted through the optical fiber to electric energy. Solar cell and antenna RF-PCB are also tested. Results presented in this paper clearly demonstrate that it is possible to build monitoring system in passive FDC. During the tests maximum obtained output power was 11 mW. However all converters provided enough power to excite 32-bit microcontroller with ARM-cores and digital thermometer.