Because of the increasing popularity of e-cigarettes, monitoring the e-cigarette market has become important for national health authorities to guarantee safety and quality. In the EU, the Tobacco Products Directive requires emission studies for e-cigarette products. The absence of industry guidelines for studying these emissions and the lack of proper validation in the literature led us to develop and validate a method using the total error approach for the determination of nicotine in e-cigarette aerosols. A commercial vaping device was used to generate aerosols, which were then collected on Cambridge filter pads and measured for nicotine concentration by UHPLC-DAD after extraction. The method was successfully validated by generating accuracy profiles, which show that the β-expectation tolerance intervals remained below the acceptance limits of ±20%. Within-run repeatability and intermediate precision were considered acceptable since the highest RSD value obtained was below 5%. The method was applied to 15 commercial e-liquids. A complete validation of a method for the analysis of e-cigarette emissions is presented, including several parameters that impact the accuracy and reproducibility. Similar systematic approaches for method development and validation could be used for other e-cigarette emission analysis methods to ensure the reliability of the measurements.
In the last decade, e-cigarettes have been marketed as a less harmful alternative to classical tobacco smoking and are currently being used by millions of people. An e-cigarette consists of an e-liquid and a heating device, generating an aerosol that the user can inhale. Recently, several studies have shown that metals and metalloids (=elementals), including As, Cd, Cr, and Pb, known carcinogens, were present in these aerosols. To ensure the accuracy of dose-toxicity estimations, it is essential to have access to reliable and reproducible methods for estimating the dose in question. Although more standardization methodologies were introduced in the analysis of elementals from aerosols, a huge divergence in sample preparation can be found in the literature. This work aimed to provide an overview of the scientific literature. Therefore, a literature search was conducted in September 2024, that followed the PRISMA guidelines. A total of 51 articles were selected for analysis and large variability in the sample preparation, specifically variations in aerosol generation characteristics and collection techniques could be observed. Despite the widespread use of methods as filters and impingers, many studies failed to validate critical steps such as aerosol recovery, blank corrections, and the extent of matrix effects. Therefore, further standardization of methodologies is urgently needed to improve the reliability of metal quantification in e-cigarette aerosols, which could potentially enhance regulatory frameworks and facilitate the routine analysis of e-cigarette emissions.