The influx of toxic pollutants into wastewater treatment plants can negatively affect the quality of the activated sludge (AS). One source is landfill leachate. The identification of microorganisms present in AS is very important, e.g., while improving wastewater treatment technology. Therefore, the aim of the study was to investigate the effect of raw leachate and after purification of Phragmites australis and Ceratophyllum demersum on the composition of the AS bacterial biocenosis. In addition, AS status was assessed by LIVE/DEAD BacLight ™ fluorescent staining. The obtained results showed that the leachate did not significantly affect the cell membranes of AS bacteria, and even a slight improvement was noted. The research carried out using the next-generation sequencing method shows that the origin of the samples (active and closed storage) and the method of processing do not significantly affect the composition of the AS bacterial biocenosis at higher taxonomic levels. However, at the species level, the appearance of bacteria not previously present in AS was observed, namely: Flavobacterium luticocti, Candidimonas nitroreducens and Nitrobacter hamburgensis. The obtained results suggest that the leachate may be a source of microorganisms positively influencing the condition of AS bacteria.
Despite many modern wastewater treatment solutions, the most common is still the use of activated sludge (AS). Studies indicate that the microbial composition of AS is most often influenced by the raw sewage composition (especially influent ammonia), biological oxygen demand, the level of dissolved oxygen, technological solutions, as well as the temperature of wastewater related to seasonality. The available literature mainly refers to the relationship between AS parameters or the technology used and the composition of microorganisms in AS. However, there is a lack of data on the groups of microorganisms leaching into water bodies whose presence is a signal for possible changes in treatment technology. Moreover, sludge flocs in the outflow contain less extracellular substance (EPS) which interferes microbial identification. The novelty of this article concerns the identification and quantification of microorganisms in the AS and in the outflow by fluorescence in situ hybridization (FISH) method from two full-scale wastewater treatment plants (WWTPs) in terms of 4 key groups of microorganisms involved in the wastewater treatment process in the context of their potential technological usefulness. The results of the study showed that Nitrospirae, Chloroflexi and Ca. Accumulibacter phosphatis in treated wastewater reflect the trend in abundance of these bacteria in activated sludge. Increased abundance of betaproteobacterial ammonia-oxidizing bacteria and Nitrospirae in the outflow were observed in winter. Principal component analysis (PCA) showed that loadings obtained from abundance of bacteria in the outflow made larger contributions to the variance in the PC1 factorial axis, than loadings obtained from abundance of bacteria from activated sludge. PCA confirmed the reasonableness of conducting studies not only in the activated sludge, but also in the outflow to find correlations between technological problems and qualitative and quantitative changes in the outflow microorganisms.
17 September 2019 in Polish Journal of Environmental Studies
The effectiveness of disinfection, as well as microbiological composition of water, are assessed by microbiological tests. The analysis usually takes from 24 to 48 hours. During this time the water produced at the water treatment plant has already been fed to the water supply system. In order to reduce the risk of bacteriological contamination, higher concentrations of disinfectants are maintained. Considering the fact that water supply systems use retention tanks with retention times of from 5 to 12 hours, microbiological tests should give the result in shorter time than water retention time in the water tanks. The aim of the study was to determine whether the bacterial community in static liquid medium with the control of absorbance change at 600 nm (OD600) can be applied as a diagnostic method at water treatment plant laboratories. The research on water and wastewater samples has shown that the duration of lag time λ depends on the approximate amount of bacteria and the initial conditions in liquid media at the start of the experiment. It has been shown that the method can be used in the future for rapid monitoring of bacteriological contamination in the water.
It is often only at the operation stage of a wastewater treatment plant that there is a need to adjust the treatment process in terms of variable hydraulic capacity, increased pollutant load, high/low concentration of suspended biomass, or the unfavorable phenomenon of reduced sedimentation capacity of the activated sludge. One of the ways to improve the treatment process efficiency is to increase the biologically active surface by using bio-carriers in the form of fibers, materials, or bio-balls. This paper presents the results of a wastewater treatment plant operation during the period of six months after the implementation of the integrated fixed-film activated sludge (IFAS) technology. The research showed that microorganisms developed both in the activated sludge and on the fibers, positively influencing the activated sludge condition. During the start-up of the IFAS process, ciliates predominated over the other species. However, as oxygen content was high (2 mg/dm3 and more) and textile beds were used, the protozoan population developed intensively, and small metazoans became increasingly common. Throughout the research period, nitrifying and phosphorus-accumulating bacteria were observed both in the activated sludge and on the fibers. Between the 59th and 184th day of operation, numerous microorganisms were detected on the fibers and in the activated sludge, testifying to low biological oxygen demand, good aerobic conditions for nitrification, and long sludge age. However, the process seemed to break down after day 72, when the occurrence of metazoan led to reduced sludge production; after day 88, chemical oxygen demand and total suspended solids in the outflow increased, and oligochaetes and rotifers dominated the suspended sludge and fibers. Results also showed that the textile bed and low ammonia concentration became an excellent substrate for the development of Stentor sp. With regard to chemical and biological oxygen demand, total nitrogen- and total phosphorus-effluent concentrations were mostly within the legally permissible limits throughout the 184 days of operation.
1 June 2019 in Journal of Water and Land Development
The increasingly stringent requirements for wastewater treatment enforce the adoption of technologies that reduce pollution and minimize waste production. By combining the typical activated sludge process with membrane filtration, biological membrane reactors (MBR) offer great technological potential in this respect. The paper presents the principles and effectiveness of using an MBR at the Głogów Małopolski operation. Physicochemical tests of raw and treated wastewater as well as microscopic analyses with the use of the FISH (fluorescence in situ hybridization) method were carried out. Moreover, the level of electric energy consumption during the operation of the wastewater treatment plant and problems related to fouling were also discussed. A wastewater quality analysis confirmed the high efficiency of removing organic impurities (on average 96% in case of BOD5 and 94% in case of COD) and suspension (on average 93%).
1 November 2020 in Desalination and Water Treatment