The Soil Moisture Active Passive (SMAP) radiometer operates in the L-band protected spectrum (1400-1427 MHz) that is known to be vulnerable to radio-frequency interference (RFI). Although transmissions are forbidden at these frequencies by international regulations, ground-based, airborne, and spaceborne radiometric observations show substantial evidence of out-of-band emissions from neighboring transmitters and possibly illegally operating emitters. The spectral environment that SMAP faces includes not only occasional large levels of RFI but also significant amounts of low-level RFI equivalent to a brightness temperature of 0.1-10 K at the radiometer output. This low-level interference would be enough to jeopardize the success of a mission without an aggressive mitigation solution, including special flight hardware and ground software with capabilities of RFI detection and removal. SMAP takes a multidomain approach to RFI mitigation by utilizing an innovative onboard digital detector back end with digital signal processing algorithms to characterize the time, frequency, polarization, and statistical properties of the received signals. Almost 1000 times more measurements than what is conventionally necessary are collected to enable the ground processing algorithm to detect and remove harmful interference. Multiple RFI detectors are run on the ground, and their outputs are combined for maximum likelihood of detection to remove the RFI within a footprint. The capabilities of the hardware and software systems are successfully demonstrated using test data collected with a SMAP radiometer engineering test unit.

The National Aeronautics and Space Administration's (NASA) Soil Moisture Active and Passive (SMAP) mission, which was launched on January 31, 2015, is providing global measurements of soil moisture and freeze/thaw state. The SMAP radiometer operates within the protected Earth Exploration Satellite Service passive frequency allocation of 1400-1427 MHz. However, unauthorized in-band transmitters and out-of-band emissions from transmitters operating at frequencies adjacent to this allocated spectrum are known to cause interference to microwave radiometry in this band. Because measurement corruption by these terrestrial transmissions, which is referred to as radio-frequency interference (RFI), threatens mission success, the SMAP radiometer includes special flight hardware to enable the detection and filtering of RFI. Results from the first year of SMAP data show the presence of RFI with frequent occurrence over Asia and Europe. During the calibration/validation stage of the mission, the RFI detection and mitigation algorithms were modified to provide enhanced performance. Analysis of the L1B_TB products indicates good algorithmic performance with respect to RFI detection and removal. However, some regions of the globe (e.g., Japan) continue to experience complete data loss. This paper summarizes updates to the SMAP RFI processing algorithms based on prelaunch tests and on-orbit measurements, as well as RFI information obtained in SMAP's first year on orbit.

An ultra-wideband radiometer has been developed to measure subsurface properties of the cryosphere including ice sheets and sea ice. The radiometer measures brightness temperature spectra from 0.5 to 2 GHz using 12 channels, each of which measures scene brightness temperatures over an ~88-MHz bandwidth resolved into 0.24-MHz intervals. The instrument was flown over northwestern Greenland in September 2016 and acquired the first, wideband, low-frequency brightness temperature spectra over the ice sheet and coastal region. The results reveal strong spatial and spectral variations that correlate well with the physical properties of the surface encountered along the flight path, which started over ocean, then passed the rock near the coast, and then up onto the ablation, wet, percolation, and dry snow zones of the interior ice sheet. In particular, strong spectral responses in percolation and dry snow zones are observed and plausibly explained by varying the distribution of horizontal density layers and isolated icy bodies in the upper portion of the firn. The success of the airborne deployment of the instrument and subsequent implementation of algorithms to limit radio frequency interference in unprotected bands is motivating continued airborne investigations as well as stimulating research into the feasibility of a spaceborne instrument.

We investigate the degree to which ultrahigh frequency radio emission can be used to estimate subsurface physical temperature in the polar ice sheets. We combine electromagnetic emission forward models with plausible models of depth-dependent physical properties in the ice sheet. Temperature models are parameterized with variables including accumulation rate, geothermal heat flux, and surface temperature. Scattering is parameterized using empirical observations of grain growth combined with measured densities. Electromagnetic absorption is modeled using dielectric dispersion processes and semiempirical models based on observations. Our models illustrate that information about East Antarctic ice sheet temperature from near the surface to near the base can be gleaned from ultrawideband radiometer data. Based on our modeling study, we illustrate an instrument concept to measure ice sheet temperature profiles comprising a novel ultrawideband radiometer.

We investigate physical effects influencing 0.5-2 GHz brightness temperatures of layered polar firn to support the Ultra Wide Band Software Defined Radiometer (UWBRAD) experiment to be conducted in Greenland and in Antarctica. We find that because ice particle grain sizes are very small compared to the 0.5-2 GHz wavelengths, volume scattering effects are small. Variations in firn density over cm- to m-length scales, however, cause significant effects. Both incoherent and coherent models are used to examine these effects. Incoherent models include a “cloud model” that neglects any reflections internal to the ice sheet, and the DMRT-ML and MEMLS radiative transfer codes that are publicly available. The coherent model is based on the layered medium implementation of the fluctuation dissipation theorem for thermal microwave radiation from a medium having a nonuniform temperature. Density profiles are modeled using a stochastic approach, and model predictions are averaged over a large number of realizations to take into account an averaging over the radiometer footprint. Density profiles are described by combining a smooth average density profile with a spatially correlated random process to model density fluctuations. It is shown that coherent model results after ensemble averaging depend on the correlation lengths of the vertical density fluctuations. If the correlation length is moderate or long compared with the wavelength (~0.6x longer or greater for Gaussian correlation function without regard for layer thinning due to compaction), coherent and incoherent model results are similar (within ~1 K). However, when the correlation length is short compared to the wavelength, coherent model results are significantly different from the incoherent model by several tens of kelvins. For a 10-cm correlation length, the differences are significant between 0.5 and 1.1 GHz, and less for 1.1-2 GHz. Model results are shown to be able to match the v-pol SMOS data closely and predict the h-pol data for small observation angles.

Microwave radiometry has provided valuable spaceborne observations of Earth's geophysical properties for decades. The recent SMOS, Aquarius, and SMAP satellites have demonstrated the value of measurements at 1400 MHz for observing surface soil moisture, sea surface salinity, sea ice thickness, soil freeze/thaw state, and other geophysical variables. However, the information obtained is limited by penetration through the subsurface at 1400 MHz and by a reduced sensitivity to surface salinity in cold or wind-roughened waters. Recent airborne experiments have shown the potential of brightness temperature measurements from 500-1400 MHz to address these limitations by enabling sensing of soil moisture and sea ice thickness to greater depths, sensing of temperature deep within ice sheets, improved sensing of sea salinity in cold waters, and enhanced sensitivity to soil moisture under vegetation canopies. However, the absence of significant spectrum reserved for passive microwave measurements in the 500-1400 MHz band requires both an opportunistic sensing strategy and systems for reducing the impact of radio-frequency interference. Here, we summarize the potential advantages and applications of 500-1400 MHz microwave radiometry for Earth observation and review recent experiments and demonstrations of these concepts. We also describe the remaining questions and challenges to be addressed in advancing to future spaceborne operation of this technology along with recommendations for future research activities.