This paper presents a multibeam hybrid beamforming (MHBF) architecture for microwave power transfer (MPT), enabling wireless power delivery to multiple receivers with a reduced number of RF chains. The proposed architecture decouples beam control into the horizontal and vertical dimensions, where horizontal multibeams are generated in the baseband through digital precoding, while the vertical beam direction is controlled by a Butler-matrix-based analog beamformer. In particular, multibeam transmission is achieved using multi-tone signals with distinct phase weights assigned to each tone, enabling beams to be steered toward different directions, while the Butler-matrix-based analog beamformer provides vertical beam-steering capability. Compared with fully digital beamforming (DBF), MHBF enables simultaneous multibeam formation in the horizontal domain with fewer RF chains, thereby reducing hardware overhead and system complexity. To validate the proposed architecture, a 5.8 GHz prototype was designed and fabricated. The experimental results demonstrate three-beam and four-beam operation under a transmit power of 30.57 dBm, while the average received RF power in the single-beam case was 12.11 dBm at a distance of 1 m. In the three-beam and four-beam cases, average received RF power levels of 7.3 dBm and 6.1 dBm per beam were achieved, respectively. RF-to-DC conversion measurements under 430 $\Omega$ and 680 $\Omega$ load conditions further showed average PCE values of up to 38.77% and 35.05% for the three-beam and four-beam cases, respectively. These results confirm the feasibility of simultaneous multibeam wireless power delivery and its potential as an effective solution for multi-receiver operation with reduced RF-chain requirements.