Agra and Kanpur are heavily polluted Indian cities and are the fourth and second largest cities in Uttar Pradesh State, respectively. PM2.5 was collected from December 2011 to May 2012 in Agra and from December 2011 to October 2012 in Kanpur every 6th day. The samples were chemically analyzed to determine organic carbon (OC), water soluble organic carbon (WSOC), elemental carbon (EC), secondary inorganic ions, and particle–phase organic compounds. A chemical mass balance (CMB) receptor model using organic tracers was used to estimate source contributions to PM2.5. Concentrations of carbonaceous aerosols were on average 23±16μg/m3 in Agra and 33±21μg/m3 in Kanpur during the winter and summer periods, and had a strong seasonal trend with highest levels in winter (December–February) and then decreasing to summer (March–May). Five primary sources were identified. In Agra, biomass burning was the major source of OC in the winter months with decreasing relative and absolute concentrations in summer. In Kanpur, biomass burning was also the most important primary source of OC, but was about half the concentration found in Agra. Mobile source contributions to OC were on average 25±9% and 25±22% in Agra and Kanpur, respectively, with similar absolute concentrations of 2.5±1.9μg/m3 in most months. Secondary organic aerosol (SOA) was estimated from non–biomass burning WSOC and the unapportioned OC, with each method indicating SOA as a major source of OC in the winter in both cities, apportioning 25% of OC in Agra and 65% in Kanpur. SOA in Kanpur in December was four times higher than in Agra. Overall, results suggest differences in aerosol chemical composition and sources at these two sites across the Indo–Gangetic plain with biomass burning making up a larger fraction of the particulate OC in Agra, and SOA being a more important contributor to OC mass in Kanpur
Dust particles, transported over long‐distances and driven by westerly winds, dominate high‐altitude (>4 km) snow darkening and melting over the Tibetan Plateau (TP). A systematic assessment of their remote sources and potential contributions remains limited. In this paper, we present a novel algorithm for source‐tracing of airborne dust designed to tackle the aforementioned challenges. The algorithm effectively constrains dust activity and guarantees precise tracking through using satellite and reanalysis‐based estimates. The high‐altitude airborne dust over the TP shows considerable spatial variation and primarily comes from the desert clusters in Central Asia, West Asia, and South Asia. The Karakum, Taklimakan, and Thar deserts are significant sources of high‐altitude airborne dust in the northwest, northeast, and southwest regions of TP, with average mass loadings (mg m−2) contributing rates of 42.2% (32.9), 49.6% (48.3), and 16.4% (32.1), respectively. The results demonstrate significant differences in how adjacent deserts affect high‐altitude snowmelt in the TP.
Dust aerosols have an impact on both public health and environmental health. The Taklimakan Desert (TD) serves as a significant source of high-altitude airborne dust over the Tibetan Plateau (TP). However, systematic understanding of its transport mechanism requires further exploration beyond isolated case studies. This study effectively identified the atmospheric circulation patterns and transport mechanisms that facilitate airborne dust movement from TD to TP in the spring, utilizing an obliquely rotated principal component analysis alongside various reanalysis and satellite datasets. The findings indicate that out of the five identified circulation patterns, three - specifically the northwest high-pressure (NWH), the northern high-pressure with warm anomaly (NH-W), and the northern high-pressure with cold anomaly (NH-C) - favor the occurrence of dust storms in the TD. In the NWH and NH-W patterns, dust is transported to the northeastern TP and the northwestern and central TP as a result of the interaction between dynamic, thermal, and terrain factors. This process features an elevated boundary layer, increased temperature, a steeper temperature lapse rate, and a more significant surface sensible heat flux in the TD. In contrast, the NH-C pattern restricts dust transport due to the presence of downdrafts along the north slope of the TP, and a reduced boundary layer and stable temperature stratification in the TD. This research provides valuable insights into the crucial function of atmospheric circulation in transporting dust from TD to TP, which is beneficial for assessing the condition of the cryosphere and developing environmental protection strategies.
Since the change in leadership, Uzbekistan is gradually transforming from an inward-looking, command-oriented economy to an outward-looking, market-oriented economy. This paper briefly presents the agricultural development and machinery usage situation in Uzbekistan. The development of agriculture has been identified as a critical component of the economic reform. The historical focus of the sector on the production of cotton and wheat has continued to dominate production. With the introduction of critical liberalization measures for the production of cotton and wheat in the beginning of 2020, the transition to higher value horticulture crops production has accelerated. Many farms are around 50 ha, and the associated farmers lack sufficient technical knowledge, farm business management capacities, business planning and/or marketing knowledge which significantly constrains their ability to attract or effectively use investment capital to develop their businesses. Moreover, very limited private advisory capacities and/or consultancies exist in rural areas. There is also growing evidence of larger private farms and agri-business companies establishing and developing their own advisory capacities to support the development of more integrated supply chains. In addition, cluster models are being promoted by the government. Modern agriculture requires a wide range of technology, knowledge and skills used by farmers and agri-businesses, from operating modern machinery and equipment in open fields and in greenhouses, to maintain minimum safety, hygiene and quality standards in all stages of production, harvesting, post-harvesting, processing and marketing. The paper discusses challenges faced in the machinery sector, technology infrastructure including technical training, machinery dealer support, repair and maintenance, and suggestions to the future.