The Three Gorges Reservoir (TGR) in China, with the largest dam in the world, stores a large volume of water and may influence the Earth’s gravity field on sub-seasonal to interannual timescales. Significant changes of the total water storage (TWS) might be detectable by satellite-based data provided by the Gravity Recovery and Climate Experiment (GRACE) mission. To detect these store water changes, effects of other factors are to be removed first from these data due to band-limited representation of near-surface mass changes from GRACE. Here, we evaluated three current popular land surface models (LSMs) basing on in situ measurements and found that the WaterGAP Global Hydrology Model (WGHM) demonstrates higher correlation than other analyzed models with the in-situ rainfall measurement. Then we used the WGHM outputs to remove climate-induced TWS changes, such as surface water storage, soil, canopy, snow, and groundwater storage. The residual results (GRACE minus WGHM) indicated a strong trend (3.85 ± 2 km³/yr) that is significantly higher than the TGR analysis and hindcast experiments (2.29 ± 1 km³/yr) based on in-situ water level measurements. We also estimated the seepage response to the TGR filling, contributions from other anthropogenic dams, and used in-situ gravity and GPS observations to evaluate dominant factors responsible for the GRACE-based overestimate of the TGR volume change. We found that the modeled seepage variability through coarse-grained materials explained most of the difference between the GRACE based estimate of TGR volume changes and in situ measurements, but the agreement with in-situ gravity observations is considerably lower. In contrast, the leakage contribution from 13 adjacent reservoirs explained ~74% of the TGR volume change derived from GRACE and WGHM. Our results demonstrate that GRACE-based overestimate TGR mass change mainly from the contribution of surrounding artificial reservoirs and underestimated TWS variations in WGHM simulations due to the large uncertainty of WGHM in groundwater component. In additional, this study also indicates that reservoir or lake volume changes can be reliably derived from GRACE data when they are used in combination with relevant complementary observations.

This study presents a methodology for constructing a quasi-geoid model with millimeter-level accuracy over the Shangyu area in China, following the guidelines of the International Association of Geodesy Joint Working Group 2.2.2, known as “The 1 cm geoid experiment”. Our approach combines two steps to ensure exceptional accuracy. First, we employ Molodensky’s theory to model the gravity field, accounting for non-level surfaces and considering complex terrain effects. Through an exhaustive analysis of these influential factors, we implement a comprehensive suite of applicable formulae within Molodensky’s series solution, enabling a thorough assessment of their impacts on height anomalies within the gravimetric quasi-geoid model. Second, we utilize a hybrid method that involves a multi-surface function using the least-squares method and a robust estimation technique. This approach enables the interpolation of quasi-geoid heights by incorporating ellipsoidal and leveling normal heights, as well as gravimetric quasi-geoid data. Through a numerical example, we demonstrate the efficiency of our solution concept, achieving an accuracy of 0.79 cm compared to independent global navigation satellite system (GNSS)/leveling measurements. By developing this methodology, our study contributes to the advancement of geodesy research and provides a valuable methodology for creating highly precise quasi-geoid models in geodetic applications.

The construction of a high-resolution dynamic water storage model, driven by the mass load of the huge water storage of the Three Gorges Reservoir (TGR), is the necessary basic data for accurately simulating changes in the geophysical field, e.g., gravity, crustal deformation, and stress. However, previously established models cannot meet the needs of accurately simulating the impoundment effects of TGR, because these models were simplified and approximated and did not consider the variation of river boundaries caused by water level changes. In this study, we combined high-resolution Gaofen-1 (GF-1) satellite imageries and real-time water level in front of the dam and extracted 31 river boundaries of the head region of TGR between the lowest (145 m) and the highest (175 m) impoundment stages based on the Normalized Differential Water Index (NDWI) and threshold segmentation from Otsu method. Developed dynamic water storage model based on higher-resolution GF-1 data can show the true river boundary changes more exactly, especially in local areas. Compared to the previous approximate models, the model that we constructed accurately depicts the boundary distribution information of the different impoundment stages. Moreover, we simulated TGR-induced gravitational effects based on the high-precision forward modeling of the dynamic water storage model (i.e., considering changes of dynamic water area and water level). The theoretical modelled results are consistent with in situ gravity measurements with the difference mainly within 10 μGal. Our results indicate that water storage variations of TGR mainly affect the gravity field response within 1000 m of the reservoir bank with its maximum amplitude up to several hundred μGal. The dynamic water storage and its simulation results of gravitational effects can effectively eliminate the impact of surface water load driven by the TGR under human control and greatly improve the signal-to-noise ratio of regional gravity observational data. Thus, this work will be beneficial in the application of geophysical and geodetic monitoring aimed to comprehensively track the local and regional geological structural stability, e.g., artificial reservoir induced earthquake and landslide.

High-precision gravity surveys are effective in detecting concealed geological structures and mineral deposits with density contrasts. In this study, 754 dense gravity measurements (average accuracy: 0.0043 mGal, or 4.3 × 10⁻⁸ m/s²) were deployed in Dingzhai Township, northeastern Zhejiang, China, to investigate concealed ore bodies and structural controls on mineralization. Using the mean-field method for source-field separation of Bouguer anomalies, combined with density inversion and edge detection, we delineated subsurface density distributions and fault systems. A newly identified “tongue-shaped” high-density anomaly near Xiashadi is interpreted as resulting from local upward intrusion of intermediate-acid porphyry from the Chencai Group basement, indicating significant exploration potential. Beneath Quaternary cover, a previously unrecognized east–west-trending concealed fault was detected, which may have controlled the structural evolution of mineralization at the Daqi’ao Ag deposit and Miaowan Cu deposit. Gravity profile inversion reveals a deep high-density anomaly beneath Xie’ao–Xi’ao’an, possibly representing the deep extension of the Hengtang Cu–Mo deposit. Low-density anomalies near Chenxi and Dongli villages are attributed to Early Cretaceous low-density intrusions (e.g., monzogranite) and multi-phase volcanism in the Shangshawan caldera. This work provides robust geophysical constraints for deep mineral exploration and advance understanding of the metallogenic tectonic evolution in northeastern Zhejiang.