Kraft lignin is an underutilized resource from the pulp and paper industry with the potential of being a key raw material for renewable fuels and chemicals. The separation of high-molecular-weight lignin from black liquor by ultrafiltration has been widely investigated, while the permeate containing low-molecular-weight lignin has received little attention. Nanofiltration can concentrate the low-molecular-weight lignin. This work, therefore, evaluates nanofiltration for the separation and concentration of low-molecular-weight lignin from the ultrafiltration permeate. For this study, eight flat polymeric sheet membranes and one polymeric hollow fiber membrane, with molecular weight cut-offs ranging from 100 to 2000 Da, were tested. A parametric study was conducted at 50 °C, 2.5–35 bar, and crossflow velocity of 0.3–0.5 m/s. At a transmembrane pressure of 35 bar, the best performing membranes were NF090801, with 90% lignin retention and 37 L/m2·h, and SelRO MPF-36, with 84% lignin retention and 72 L/m2·h. The other membranes showed either very high lignin retention with a very low flux or a high flux with retention lower than 80%. Concentration studies were performed with the two selected membranes at conditions (A) 50 °C and 35 bar and (B) 70 °C and 15 bar. The NF090801 membrane had the highest flux and lignin retention during the concentration studies. Overall, it was shown that the nanofiltration process is able to produce a concentrated lignin fraction, which can be either used to produce valuable chemicals or used to make lignin oil.
10 October 2024 in ACS Sustainable Chemistry & Engineering
The valorization of lignin, an underutilized renewable resource with high aromaticity, is gaining significance. In this study, an aqueous electrolyte was prepared utilizing lignin from Miscanthus x giganteus , elephant grass (EGL), and employed as a redox species for redox flow batteries (RFBs). Oxidative depolymerization was utilized to alter the structure of EGL to generate electrochemical functionalities suitable for RFB applications. Central composite design (CCD)–based response surface methodology (RSM) was applied to determine the optimal operating conditions for maximizing the monomer yield. The effects of four independent parameters were investigated for the depolymerization process: temperature (160–220°C), pressure (5–15 bar O 2 ), residence time (30–90 min), and lignin concentration (50–150 g/L). The highest monomer yield was predicted to be 5.3 wt% under optimized process parameters of 177°C, 12 bar O 2 , 85 min, and an EGL concentration of 52 g/L, which was experimentally validated with an average yield of 5.7 ± 0.45 wt%. The oxidatively depolymerized lignin (OEGL) displayed favorable electrochemical reversibility and stability for 200 cycles at a constant current of 1 mA/cm 2 . A significant improvement in the discharge capacity of the RFB was also achieved when utilizing the OEGL compared to the case using EGL. The findings of this study establish a foundation for the development of sustainable and potentially affordable RFBs suitable for commercial production. This approach also adds a new aspect to existing pulp and paper mills and biorefinery facilities by functioning as inexpensive storage sites for variable renewable electricity.