This study delves into the application of oxidative refining for the recovery and concentration of precious metals, namely palladium (Pd) and gold (Au), from waste electrical and electronic equipment by WEEE recycling, leveraging pyrometallurgical techniques. The primary objective is to optimize refining parameters, encompassing variations in gas pressure, temperature, and gas composition, to maximize the extraction and purification of precious metals from recycled materials. Through an array of comprehensive characterization techniques, encompassing microstructural analysis, elemental composition assessment, and metal concentration measurement, this study scrutinizes the potential of oxidative refining. The conclusive findings underscore the remarkable potential of oxidative refining in augmenting the efficiency and effectiveness of metal recovery from waste printed circuit boards (PCBs), with a pronounced emphasis on the concentration of Pd and Au. This research not only highlights the promise of oxidative refining but also concludes that optimizing process parameters, such as a N₂/O₂ mixed gas pressure of 4 L/min, a process time of 40 min, and a temperature of 1400 °C, is imperative for achieving the highest efficiency in metal recovery from electronic waste, especially precious metals like Pd and Au. It further contributes to the sustainable management of electronic waste and the strategic extraction of valuable precious metals.

The rapid growth of the electric vehicle (EV) market has highlighted the critical importance of securing a stable supply chain for lithium-ion battery (LIB) resources, thereby increasing the need for efficient recycling technologies. Among these, lithium recovery remains a major challenge due to significant losses during conventional processes. In this study, a chlorination roasting process was introduced to convert Li₂O in spent LIBs into LiCl, which was subsequently evaporated for selective lithium extraction and recovery. Roasting experiments were conducted under air, vacuum, and N₂ conditions at 800–1000 °C for 1–5 h, with Cl/Li molar ratios ranging from 0.5 to 8. The optimal condition for lithium evaporation, achieving 100% recovery, was identified as 1000 °C for 5 h, with a Cl/Li molar ratio of 6 under vacuum. Following lithium removal, residual valuable metals were extracted through H₂SO₄ leaching, and the effects of acid concentration and H₂O₂ addition on leaching efficiency were examined. The air-roasted samples exhibited the highest leaching performance, while the vacuum- and N₂-roasted samples showed relatively lower efficiency; however, the addition of H₂O₂ significantly enhanced leaching yields in these cases.

The rapid increase in electronic waste poses a significant environmental issue, with copper-rich residues considered among the most valuable fractions. Extracting copper of high purity from these materials is critical for advancing sustainable resource utilization. In this work, an oxidative refining approach employing a FeO–CaO–SiO₂ slag matrix was investigated to purify copper-bearing sludge. The method facilitated stable slag generation and ensured distinct separation between the metallic phase and slag. Although Fe and Si were removed effectively at relatively low processing temperatures, complete removal of Sn and S occurred only at 1300 °C, with traces of copper oxides persisting in the refined alloy. Overall, the findings suggest that the proposed slag system offers a reliable strategy for producing high-purity copper from secondary sources, underscoring its relevance in sustainable recycling of copper-enriched wastes.