Municipal waste management has become a challenging issue with the rise in urban populations and changes in people’s habits, particularly in developing countries. Moreover, government policy plays an important role associated with municipal waste management. Thus, this research proposes the regional location routing problem (RLRP) model and multi-depot regional location routing problem (MRLRP) model, which are extensions of the location routing problem (LRP), to provide a better municipal waste collection process. The model is constructed to cover the minimum number of depot facilities’ policy requirements for each region due to government policy, i.e., the large-scale social restrictions in each region. The goal is to determine the depot locations in each region and the vehicles’ routes for collecting waste to fulfill inter-regional independent needs at a minimum total cost. This research conducts numerical examples with actual data to illustrate the model and implements a hybrid genetic algorithm and simulated annealing optimization to solve the problem. The results show that the proposed method efficiently solves the RLRP and MRLRP.
2 September 2019 in Multidiscipline Modeling in Materials and Structures
Purpose: The purpose of this paper is to investigate prediction and optimization of multiple performance characteristics in the wire electrical discharge machining (wire-EDM) process of SKD 61 (AISI H13) tool steel. Design/methodology/approach: The experimental studies were conducted under varying wire-EDM process parameters, which were arc on time, on time, open voltage, off time and servo voltage. The optimized responses were recast layer thickness (RLT), surface roughness (SR) and surface crack density (SCD). Arc on time was set at two different levels, whereas the other four parameters were set at three different levels. Based on Taguchi method, an L18 mixed-orthogonal array was selected for the experiments. Further, three methods, namely grey relational analysis (GRA), backpropagation neural network (BPNN) and genetic algorithm (GA), were applied separately. GRA was performed to obtain a rough estimation of optimum drilling parameters. The influences of drilling parameters on multiple performance characteristics were determined by using percentage contributions. BPNN architecture was determined to predict the multiple performance characteristics. GA method was then applied to determine the optimum wire-EDM parameters. Findings: The minimum RLT, SR and SCD could be obtained by setting arc on time, on time, open voltage, off time and servo voltage at 2 ms, 3 ms, 90 volt, 10 ms and 38 volt, respectively. The experimental confirmation results showed that BPNN-based GA optimization method could accurately predict and significantly improve all of the responses. Originality/value: There were no publications regarding multi-response optimization using a combination of GRA and BPNN-based GA methods during wire-EDM process available.
Carbon Fiber Reinforced Polymer (CFRP) has been widely used in various industries, including automotive, trains, and especially aerospace as a substitute for metal materials because of its high specific strength. Milling is one of the most commonly used machining processes in composites. Thus, it is necessary to determine the exact machining process parameters so that the specifications of the components are met. Moreover, suitable optimization method is needed to obtain machining parameters that produce small delamination and low cutting force. Full factorial design (2x3x3) with spindle speed, cutting speed and depth of cut as an input and the responses of cutting force and delamination was carried out in this experiment. A genetic algorithm was used as an optimization method, while backpropagation neural networks (BPNN) were used to apply complex non-linear equations. The BPNN model optimized using the GA method has been successfully developed in which the end milling process on CFRP material gains a mean square error (MSE) of 0.0246. This value indicates that the BPNN-GA model can be used as a predictor of the end milling CFRP process and eventually used to optimize the machining process.