Mzamo Shozi

Prof. Mzamo Shozi

Chemistry, University of KwaZulu-Natal, Durban, KwaZulu-Natal, South Africa
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 September 2016 in ACS Sustainable Chemistry & Engineering
Verified
Journal Article
Closed access
Mzamo ShoziMzamo Shozi
Mzamo Shozi
Venkata D. B. C. DasireddyVenkata D. B. C. Dasireddy
Venkata D. B. C. Dasireddy
SSSooboo Singh
Sooboo Singh
PMPheladi Mohlala
Pheladi Mohlala
DMDavid Morgan
David Morgan
HFHolger B. Friedrich
Holger B. Friedrich

27 June 2024 in Results in Chemistry
Verified
Journal Article
Open access
ABAmanda S. Buthelezi
Amanda S. Buthelezi
CTChelsea.L. Tucker
Chelsea.L. Tucker
HHHero J. Heeres
Hero J. Heeres
Mzamo ShoziMzamo Shozi
Mzamo Shozi
HBHendrik H. van de Bovenkamp
Hendrik H. van de Bovenkamp
PNPinkie Ntola
Pinkie Ntola

28 June 2017 in Sustainable Energy & Fuels
Verified
Journal Article
Closed access
PDF file
Mzamo ShoziMzamo Shozi
Mzamo Shozi
VDVenkata D. B. C. Dasireddy
Venkata D. B. C. Dasireddy
SSSooboo Singh
Sooboo Singh
PMPheladi Mohlala
Pheladi Mohlala
DMDavid Morgan
David Morgan
HFHolger B. Friedrich
Holger B. Friedrich
Cu and Re monometallic and bimetallic catalysts supported on ZnO were synthesized via wet impregnation. The catalysts were characterized using XRD, TPR, Pulse TPD, TEM, SEM, XPS and BET surface area. TPR results showed that the presence of rhenium increases the reduction temperature of the catalysts and TPD showed that the presence of copper decreases the Brønsted acidity of the catalysts. SEM showed an improved distribution of metal oxide on the support after the incorporation of rhenium. These catalysts were evaluated in the hydrogenolysis of glycerol in a continuous flow fixed bed reactor in a temperature range of 150–250 °C and a H2 pressure of 60 bar. All catalysts were active, with activity being higher over the rhenium containing catalysts. At the lowest temperature (150 °C), 1,2-propanediol had the highest selectivity which decreased with increase in temperature. Subsequently, the selectivity to lower alcohols, such as methanol, ethanol and 1-propanol, and ethylene glycol increased with temperature as 1,2-propanediol reacted further to these products due to C–C bond cleavage. This was also observed when the hydrogen content was increased at constant temperature (250 °C). All catalysts were found to be stable in terms of activity and selectivity to lower alcohols over a period of at least 24 hours at 250 °C and 60 bar H2 pressure.

22 July 2016 in Surface and Interface Analysis
Verified
Journal Article
Closed access
PDF file
SIS. Iqbal
S. Iqbal
Mzamo ShoziMzamo Shozi
Mzamo Shozi
DMDavid Morgan
David Morgan

26 January 2022 in ACS Omega
Verified
Journal Article
Open access
RCRevana Chanerika
Revana Chanerika
Mzamo ShoziMzamo Shozi
Mzamo Shozi
HFHolger B. Friedrich
Holger B. Friedrich
Catalysts featuring 2, 5, and 10 wt % silver supported on alumina were prepared by the deposition precipitation method and activated under hydrogen. All catalysts were characterized by Brunauer–Emmett–Teller (BET) measurements, inductively coupled plasma-optical emission spectrometry (ICP-OES), backscattered electron scanning electron microscopy (BSE-SEM), high-resolution transmission electron microscopy (HR-TEM), hydrogen-temperature-programmed reduction (H2-TPR), H2-chemisorption, thermogravimetric analysis (TGA), infrared (IR) spectroscopy, X-ray diffraction (XRD), Raman spectroscopy, and isopropylamine (IPA) TPD and evaluated in a continuous plug flow fixed-bed reactor. Metal nanoparticles with average sizes of 4.5, 11.5, and 21.1 nm were identified by HR-TEM for the 2, 5, and 10 wt % Ag/Al2O3 catalysts, respectively. A conversion of 99% was observed for 1-octyne over particles between 10 and 15 nm in size, with stable operation up to 24 h (decreasing thereafter) at a temperature of 140 °C and a pressure of 30 bar in the competitive hydrogenation reaction. No conversion of 1-octene was noted in competitive reactions (mixed 1-octyne and 1-octene feed) but rather a gain of 1-octene throughout the 72 h time-on-stream. The performance of all catalysts was influenced by both the metal and support, where the latter impacted the overall acidity of the catalysts, thus affecting their long-term stability.

30 May 2019 in Sustainable Energy & Fuels
Verified
Journal Article
Closed access
PDF file
Mzamo ShoziMzamo Shozi
Mzamo Shozi
Venkata D. B. C. DasireddyVenkata D. B. C. Dasireddy
Venkata D. B. C. Dasireddy
SSSooboo Singh
Sooboo Singh
Alisa DorasamyAlisa Dorasamy
Alisa Dorasamy
PMPheladi Mohlala
Pheladi Mohlala
HFHolger B. Friedrich
Holger B. Friedrich
Ni/Al2O3 and Ni/SiO2 catalysts with nominal loadings of 30 wt% Ni and promoted with 1 wt% Re were synthesized via wet impregnation. The catalysts were characterized using XRD, TPR, TPD, TEM, SEM and BET surface area. TPR results showed that promotion with rhenium decreases the reduction temperature of the catalysts and TPD showed that it increases the acidity of the catalysts. SEM showed discernible changes in the distribution of metal oxide on the support after the incorporation of rhenium. These catalysts were evaluated in the hydrogenolysis of glycerol in a continuous flow fixed bed reactor in a temperature range of 250–325 °C and at a H2 pressure of 60 bar. All catalysts were active, with activity increasing by 3 or 4 times when rhenium was added due to an increase in acidity of the catalyst, thus aiding the dehydration step to form ethylene glycol and 1,2-propanediol. At the highest temperature (325 °C), ethylene glycol and 1,2-propanediol had the lowest yield and, consequently, the yield of lower alcohols such as methanol, ethanol and 1-propanol increased with temperature as the ethylene glycol and 1,2-propanediol reacted further to give these products due to C–C bond cleavage. The Re-promoted catalysts showed a higher total yield of lower alcohols compared to the unpromoted catalysts. Among all the catalysts Re–NiAl2O3 showed the highest TOF which is also in agreement with the acidic site concentration, metallic surface area and metal dispersion of the catalyst.