In the present study, geologic lineaments have been extracted by automatic lineament extraction algorithm of Geomatica software, using digital elevation model (DEM) derived shaded relief images being illuminated with multiple illumination directions. Fieldwork has been carried out for ground truth and in search of any possible evidence of movement along the extracted lineaments in the Kandiah valley in Kohistan district. A regional lineament (possible fault) has been inferred in recent a geological study (e.g. Zeilinger, 2002) that has been found to cross the Kandiah valley. The analysis and ground verification of automatic extracted geologic lineaments revealed that Kandiah valley is in one block without having any regional geological lineament. However, a good correlation was found among the predominant orientations of extracted geologic lineaments and the measured trends of rock features such as rock foliation, drainage pattern and linear ridges. Based on extracted lineaments, no pronounced lineament or fault with the regional extension was identified. This finding is consistent with the field observations as no defenite evidence of fault was found in the study area.

This paper encompasses the engineering geological properties of rock mass along the power tunnel of hydropower in Kohistan, Khayber Pakhtun Khawa (KPK), Pakistan. The major geological units of the study area are Chilas complex (CC) and Gilgit complex (GC) that consists mostly of igneous and metamorphic rocks. Discontinuity surveys were conducted to classify the rock mass by utilizing rock mass rating (RMR) and tunneling quality index (Q) classification systems. RMR system involves collection of data for parameters of rock strength, RQD, spacing of discontinuities, condition of discontinuities, groundwater condition and Q system involves rock quality designation (RQD), joint roughness (J_r), joint sets (J_s), joint alteration (J_a), stress reduction factor (SRF) and joint water reduction (J_w). RMR values ranges from 46 to 66 (fair to good) for rock unit of Chilas complex (CC) and 50 to 58 (fair) for rock unit of Gilgit complex (GC). The evaluated values of tunnel quality by Q-system are 1.55 to 6.4 (poor to fair) for Chilas complex (CC) and 1.35 to 1.84 (poor) for Gilgit complex (GC). The required support along the tunnel route is also estimated by both classification systems. Unwedge program is used to analyze the unstable zones due to the intersection of different joint sets. Total 14 cases are analyzed in Unwedge from which 3 cases have failure potential with FOS less than 1. These failure potential blocks can become stable by applying further support of rock bolting and shotcrete layer.

This study presents a detailed geological and geotechnical analysis of Dewal landslide along Murree-Muzaffarabad road, Pakistan. The study area is situated in a tectonically active region of the earth where mass movements like rock fall, rockslides and slumps cause adverse economic loss through disruption of travelling on roads. The study has the main focus on factors responsible for its instability together with stability analysis using limit equilibrium method by use of computer program Slide (version 5.0). The input parameters of rock mass was evaluated by field investigations and laboratory testing. To analyze the net deposit and net slide mass of the landslide area, multi-date point’s data of 2008 and 2012 of the slide area was obtained and their digital elevation models were generated by using Inverse distance weighting (IDW) technique in ArcGIS 9.3. The study has concluded that the present slope instability is the function of a specific deformation pattern in the rock units (leading towards the possibility of a shear plane under the slid mass), surface and subsurface drainage and the engineering behavior of the overburden and underlying rock units. This study recommends several protection parameters for landslide and suggests that detailed investigation of Dewal landslide is required for long term stability.