The major challenges facing oil production during/after secondary recovery include oil entrapment by water and high water mobility. Hence, currently, Enhanced Oil Recovery (EOR) is considered a key solution for increasing oil production upon reaching the tertiary production phase. Unfortunately, EOR still has its drawbacks including the degradation of the chemicals (polymers and surfactants) used under reservoir conditions, large required volumes of chemicals, and their high cost. Nanotechnology is an emerging technology that has profoundly changed the course of different applications in various fields. In petroleum engineering, this modification can be attributed to the nanomaterials’ unique properties including high surface-to-volume ratio, wettability control, and interfacial tension reduction. To this end, the use of nanomaterials to enhance oil recovery is a very attractive, yet challenging task. This mini-review focuses on the recent efforts to explore the effects of various nanomaterial additives on the EOR process as well as the proposed mechanisms.
20 February 2008 in Journal of Materials Chemistry
Described is the synthesis of TiO2 nanotube array films by anodization of Ti foil in HCl electrolytes containing different H2O2 concentrations. Highly ordered nanotube arrays up to 860 nm in length, 15 nm inner pore diameter, and 10 nm wall thickness were obtained for one hour anodizations using a 0.5 M HCl aqueous electrolyte containing 0.1–0.5 M H2O2 concentrations for anodization potentials between 10–23 V. The use of ethylene glycol as the electrolyte medium significantly alters the anodization kinetics and resulting film morphologies; nanotube bundles several microns in length achieved for anodization potentials between 8 V and 18 V in only a few minutes. The nanotube arrays obtained from the ethylene glycol electrolytes show relatively higher photocurrents, ≈0.8 mA cm−2 under AM 1.5. Under 100 mW cm−2 AM 1.5 illumination a 500 °C annealed 1 cm2 nanotube array sample, obtained by anodization of a Ti foil sample in ethylene glycol + 0.5 M HCl + 0.4 M H2O2 electrolyte, demonstrates a hydrogen evolution rate of approximately 391 μL h−1 by water photoelectrolysis, time-power normalized evolution rate of 3.9 mL W−1 h−1, with water splitting confirmed by the 2 : 1 ratio of evolved hydrogen to oxygen.
18 January 2023 in Environment, Development and Sustainability
Waste from electrical and electronic equipment exponentially increased due to the innovation and the ever-increasing demand for electronic products in our life. The quantities of electronic waste (e-waste) produced are expected to reach 44.4 million metric tons over the next five years. Consequently, the global market for electronics recycling is expected to reach $65.8 billion by 2026. However, electronic waste management in developing countries is not appropriately handled, as only 17.4% has been collected and recycled. The inadequate electronic waste treatment causes significant environmental and health issues and a systematic depletion of natural resources in secondary material recycling and extracting valuable materials. Electronic waste contains numerous valuable materials that can be recovered and reused to create renewable energy technologies to overcome the shortage of raw materials and the adverse effects of using non-renewable energy resources. Several approaches were devoted to mitigate the impact of climate change. The cooperate social responsibilities supported integrating informal collection and recycling agencies into a well-structured management program. Moreover, the emission reductions resulting from recycling and proper management systems significantly impact climate change solutions. This emission reduction will create a channel in carbon market mechanisms by trading the CO2 emission reductions. This review provides an up-to-date overview and discussion of the different categories of electronic waste, the recycling methods, and the use of high recycled value-added (HAV) materials from various e-waste components in green renewable energy technologies.