A solar concentrator was designed using a detailed one-dimensional numerical model previously developed to describe the heat and fluid-dynamic behavior inside a compound parabolic concentrator (CPC). The governing equations (continuity, momentum and energy) inside the CPC absorber tube, together with the energy equation in the tube wall and the thermal analysis in the solar concentrator were solved.Two CPC geometries were proposed based on numerical simulation and commercial availability of materials; one of this is tested in this work.A ray tracing analysis was made for this configuration to quantify optical energy losses due to truncation. Then, a module with aperture area of 2.1 m2 was constructed. The module has 12 CPCs, each one with real concentration ratio of 1.8, acceptance angle of 30°, and a tubular receiver covered by a selective surface.An experimental setup was designed and built to test different operational conditions for the module; for example mass flow rate and inlet temperature. The experimental setup has the following elements: The CPC, two water storage tanks, a recirculation pump, and a support structure that allows positioning the CPC at different angles.Experimental results obtained using the Mexican standard NMX-ES-001-NORMEX-2005 show that this technology could be able to supply stable temperatures for industrial processes. However, a new prototype is going to be developed and constructed in order to improve some manufacturing errors detected in these experimental tests
The analysis of solar thermal systems through numerical simulation is of great importance, since it allows predicting the performance of many configurations in any location and under different climatic conditions. Most of the simulation tools are commercial and require different degrees of training; therefore, it is important to develop simple and reliable methodologies to obtain similar results. This study presents a parametric methodology to size stationary solar collector fields, with operating temperatures up to 150 °C. The costs of the collector loop piping and the pumping power of different series–parallel arrays is considered. The proposed tool was validated with experimental data and through simulations using commercial software. The tool allows establishing series–parallel arrays and calculates the volume of the storage tank according to the thermal load. The calculation is based on the system energy balance, where the mass flow and the heat losses in the interconnections of the collectors are taken into account. The number of collectors and the optimal series–parallel array were determined. The results show deviations lower than 7% in the relative error of the temperature profiles and in the solar fraction, with respect to the results obtained by dynamic simulations.