We measure evaporation rates from water kept in an insulated tank and which is at a temperature higher than the ambient. Different schemes are used to obtain different temperature profiles in the water layer: a) water is heated from bellow, b) water left to cool after being heated, c) water heated from above with an IR heater, d) water heated from above in a very shallow tank. The idea of having these different schemes is to check the role of water side convection on evaporation rates. In cases a) and b) unstable stratification causes convection; in case c) we have stable stratification, and in case d), the temperature is uniform in the water layer. The heating-from-above experiments simulate some aspects of evaporation from natural bodies, like lakes, due to solar radiation. Evaporation rates were measured using a precision balance. Temperatures were measured in the water and in the ambient, and a thermal camera was used to monitor the water surface temperature and visualize the convection patterns. We present results of evaporation rates under the different conditions
We report an experimental study of evaporation of two configurations of layered porous media that are heated from above by infrared (IR) radiation having ~1,000 W/m2 intensity. We used nearly monodisperse glass beads in each of the layers. The two configurations are (1) coarse and fine beads, stacked side by side and (2) fine beads over coarse beads (FoC). The IR heater mimics the natural evaporation process in soils, and the aim is to study, using three diagnostic tools, how the layering affects the evaporation process, and compare it with the homogeneous porous medium case. For each experiment we use three diagnostics simultaneously, evaporation rate measurement using a precision balance, surface temperature imaging using an IR camera, and visualization of the evaporation process with fluorescein dye. The constant (evaporation) rate period (CRP) regime, found in homogeneous porous media, is drastically changed for the two layered configurations. We show new results for side‐by‐side configuration. In the FoC configuration we show that the near‐surface water content in the finer particles does not change in CRP and a true constant evaporation rate is possible. The average water depth at end of CRP in the porous medium, for a wide range of diameter ratios for the FoC configuration are compared with the predictions from theoretical relations proposed by Shokri et al. (2010, https://doi.org/10.1029/2009JB006743) and Assouline et al. (2014, https://doi.org/10.1002/2013WR014489). Using a simple surface energy budget, we show that knowing the surface temperature, the evaporation rate can be estimated with reasonable accuracy (±5%) during drying of a porous medium.
1 November 2018 in International Journal of Thermal Sciences
Evaporation from a porous medium goes through three different stages; the physics of drying is completely different in each stage. In the first stage, liquid films maintain high hydraulic conductivity leading to high evaporation rates; it mainly depends on the atmospheric demand. Duration of stage 1 is given in terms of a suitable length scale, Lcap, which originates from the competition between the capillary, gravitational, and viscous forces. It is known that Lcap depends strongly on the particle size and distribution of the pore sizes in a porous medium. We report experiments of evaporation from an initially saturated homogeneous porous medium consisting of nearly mono-disperse (0.70–0.85 mm diameter) glass beads, while heating from above using IR radiation. We found significant changes in Lcap values depending on the incident heat load. We discuss these results based on changes in the fluid properties, such as surface tension and sub-surface temperature gradient. It is expected that such a study would be beneficial not only to the drying industries but also in the agricultural sector and cooling devices.
1 February 2020 in International Journal of Thermal Sciences