Water-processed, aqueous electrolyte supercapacitors are demonstrated incorporating an alternating copolymer of a functionalized 3,4-propylenedioxythiophene unit with a 2,2′-bis(3,4-ethylenedioxythiophene) unit (PE2) into carbon nanotube textiles. The side chains functionalizing PE2 allow the solubility to be tuned from the organic soluble precursor polymer, to a water-soluble polyelectrolyte, and finally to a solvent resistant form by a dilute acid wash (SR-PE2). Thin SR-PE2 films (60 μg cm−2) are electroactive over a wide potential window with a mass capacitance of 54 F g−1 at a discharge rate of 1.6 s (38 A g−1). These films exhibit a 65% capacitance retention at an 80 millisecond discharge time (560 A g−1). Flexible, free-standing electrodes were fabricated by depositing SR-PE2 onto a nonwoven carbon nanotube textile (CNT-T) and were assembled into symmetrical, flexible supercapacitors where the addition of polymer resulted in a boost in volumetric capacitance by 400 percent compared to the bare CNT-T electrode. Independent of whether the SR-PE2 films are cast from an organic solvent or water, device electrodes exhibit 11.4 F cm−3 (45 mF cm−2, 15.9 F g−1) which leads to an energy density of 0.10 mW h cm−3 at 7.5 mW cm−3 considering the total device volume. The CNT-T imparts a high degree of flexibility allowing the supercapacitors to retain 88% of their charge storage capacity when bent to a 0.8 mm radius as well as complete capacitance retention after 2000 bending cycles to a 3.5 mm radius. The devices assembled in air with a benign KCl electrolyte maintained 83% capacitance retention after 10 000 charge/discharge cycles highlighting the stability of these materials and utility for this processing approach for high throughput energy storage devices.
Conventional soilless growing media, such as perlite, are mined from nonrenewable resources and can only be disposed of in landfills after limited use. There is a need to investigate novel, sustainable growing media adapted from waste or engineered to be reused over multiple cycles. This study investigated waste almond shells and a recycled plastic drainage plank as hydroponic growing media alternatives. Physiochemical properties were evaluated, and a germination and greenhouse growth trial was conducted to understand the effect these media have on production and nutritional quality of lettuce (Lactuca sativa L. cv. Catalogna Verde). Drought testing was carried out to understand how the media affected the lettuce’s response to water stress. In comparison to perlite, yields under regular irrigation were reduced by 52% in almond shells and 72% in plastic planks, although lettuce grown in almond shells still obtained commercially relevant yields. Reduced yields in almond shells were likely caused by the shell’s high salinity. Lettuce growth in plastic planks was limited by impeded root growth and low water-holding capacity. In conclusion, with minor alterations, almond shells could be used as a sustainable growing media alternative to perlite in hydroponic lettuce production. More research is needed to manufacture the planks to be conducive to plant growth.