This comprehensive study investigates the micro-milling of a Mg13Sn alloy, a material of considerable interest in various high-precision applications, such as biomedical implants. The main objective of the study was to explore the optimizations of variable feed per tooth (fz), cutting speed (Vc), and depth of cut (ap) parameters on the key outcomes of the micro-milling process. A unique experimental setup was employed, employing a spindle capable of achieving up to 60,000 revolutions per minute. Additionally, the study leveraged linear slides backed by micro-step motors to facilitate precise axis movements, thereby maintaining a resolution accuracy of 0.1 μm. Cutting forces were accurately captured by a mini dynamometer and subsequently evaluated based on the peak to valley values for Fx (tangential force) and Fy (feed force). The study results revealed a clear and complex interplay between the varied cutting parameters and their subsequent impacts on the cutting forces and surface roughness. An increase in feed rate and depth of cut significantly increased the cutting forces. However, the cutting forces were found to decrease noticeably with the elevation of cutting speed. Intriguingly, the tangential force (Fx) was consistently higher than the feed force (Fy). Simultaneously, the study determined that the surface roughness, denoted by Sa values, increased in direct proportion to the feed rate. It was also found that the Sa surface roughness values decreased with the increase in cutting speed. This study recommends a parameter combination of fz = 5 µm/tooth feed rate, Vc = 62.8 m/min cutting speed, and ap = 400 µm depth of cut to maintain a Sa surface roughness value of less than 1 µm while ensuring an optimal material removal rate and machining time. The results derived from this study offer vital insights into the micro-milling of Mg13Sn alloys and contribute to the current body of knowledge on the topic.
1 January 2016 in Materials Science and Engineering: A
In this study, micro machinability of Mg5Sn4Zn (TZ54) alloy produced by a hot-pressing process (one of the powder metallurgy methods) is investigated. For this purpose, micro-milling experiments were carried out, considering different cutting parameters. In order to determine the appropriate cutting parameters, the variation of cutting forces, surface quality and burr width were investigated. The cutting forces obtained in micro-milling of the TZ54 alloy are relatively small compared to other biomedical materials. In terms of both cutting forces and surface roughness, the minimum chip thickness is between 7% and 34% of the tool edge radius. However, compared to alloys such as Ti6Al4V and 316 L, the burr width is about 80% smaller. An important contribution of the study is that the minimum chip thickness (0.1 μm) has been confirmed in terms of both cutting force and surface roughness. In addition, even at high material removal rates, the minimum cutting forces are important findings of the study. The predominant wear mechanism in the cutting tool is abrasive wear. In view of tool life, surface roughness and burr formation, it is envisaged that the TZ54 alloy can be an easy machinable, alternative biomedical material.