Data sets of internal resistances and open-circuit voltage of a particular battery are needed in ANSYS Fluent program to predict the heat generation accurately. However, one set of available data, called Chen’s original, does not cover all types and shapes of batteries. Therefore, this research was intended to study the effects of shapes and polarization chemistries on heat generation in Li-ion batteries. Two kinds of material chemistries (nickel manganese cobalt oxide, NMC, and lithium iron phosphate, LFP) and three forms (cylindrical, pouch, and prismatic) were studied and validated with the experiment. Internal resistance was unique to each cell battery. Differences in shapes affected the magnitude of internal resistance, affecting the amount of heat generation. Pouch and prismatic cells had lower internal resistance than cylindrical cells. This may be the result of the forming pattern, in which the anode, cathode, and separator are rolled up, making electrons difficult to move. In contrast, the pouch and prismatic cells are formed as sandwich layers, resulting in electrons moving easily and lowering the internal resistance. The shapes and chemistries did not impact the entropy change. All batteries displayed exothermic behavior during a lower SOC that gradually became endothermic behavior at around 0.4 SOC onwards.
Temperature stratification between outgoing hot water and incoming cold water is a key factor in diminishing energy loss during the discharging process and maximizing the useful hot water delivered from the tank or enhancing the thermal efficiency of the heating device during the heating process. In this study, the inlet structure and the obstacle plate were designed and modified based on two main factors, the reduction of inlet water velocity and the stipulation of the water recirculation area, to develop temperature stratification through the computational fluid dynamics method. The simulation model’s accuracy was validated against the experimental results. The results showed that using the equalizer as an inlet pipe’s auxiliary device was the best approach for decreasing the inlet water velocity, which resulted in enhancing temperature stratification. The discharging efficiency improved from 77.3% for the original tank model to 86.1% for the tank with equalizer IV model, which meant an additional 45 L of useful hot water was gained from the good temperature stratification storage tank. The installation of the obstacle plate for controlling the turbulence zone could not improve temperature stratification significantly, which resulted in an increase in discharging efficiency by only 4% more than the original tank model.