In this study, multi-objective optimization of mechanical properties in friction-stir-welding of AH12 1050 aluminum alloy is performed using a combination of the response surface method and multi-objective particle swarm optimization algorithm. The process parameters are considered as tool pin diameter, shoulder diameter, rotational speed, feed speed, and tool tilt angle. The heat-affected zone’s yield strength, fracture strain, impact toughness, and hardness on the advancing and retreating sides are selected as the objective functions. Threaded and simple conical pins are utilized to evaluate the effect of the pin geometry on the specimen mechanical properties. Optimization model outputs are in agree with the obtained experimental results. The effects of process parameters on the mechanical properties of the friction-stir-welded sheets are studied. Results reveal that the lower rotational speed and higher feed speed improve the material strength and hardness. Moreover, the microstructural analysis demonstrates that the proposed methodology can achieve a fine-grained structure with the minimum defects. Improvement in the material flow is observed for the threaded cylindrical pin compared with the conical pin due to the geometric shape of the tool pin leading to more functional mechanical properties. It is found that the combination of the response surface methodology and the multi-objective particle swarm algorithm led to the modeling and optimization of the process with outstanding accuracy and low experimental cost.
28 September 2013 in Journal of Failure Analysis and Prevention
Coefficient of friction plays a key role in the metal forming process, especially at high temperatures, to reduce the required energy for material forming. In this study, the compression ring test was experimentally carried out to determine the shear friction coefficient of the hot-working steel alloy A105 at 1050 °C. The friction coefficient was evaluated for specimens without lubrication and graphite, mica, and glass powder lubricants. The variations of specimen inner diameter during the deformation process were then calculated at several coefficients of frictions using the finite element method. By employing experimental and numerical results, the coefficient of friction for each lubricant was reasonably determined. The results showed that the coefficient of friction was predicted for dry samples as 0.62. Moreover, the friction coefficient values using graphite, mica, and glass powder were obtained 0.46, 0.29 and 0.18, respectively.
To improve the formability in the deep drawing of tailor-welded blanks, an adjustable drawbead was introduced. Drawbead movement was obtained using the multi-objective optimization of the conflicting objective functions of the fracture and centerline deviation simultaneously. Finite element simulations of the deep drawing processes were conducted to generate observations for optimization. The response surface method and artificial neural network were used to determine the relationship between variables and objective functions; the procedure was applied to a circular cup drawing of the tailor-welded dual-phase steel blank. The results showed that the artificial neural network had better prediction capability and accuracy than the response surface method. Additionally, the non-dominated sorting-based genetic algorithm (NSGA-II) could effectively determine the optima. The adjustable drawbead with the optimized movement was confirmed as an efficient and effective solution for improving the formability of the deep drawing of tailor-welded blanks.