In autonomous vehicle platooning, members of the platoon not only use their own sensor data for making driving decisions. They also rely on data shared by other members of the platoon. This article proposes a security protocol to verify the established communication link between two vehicles driving in succession. Optical camera communications (OCC) via modulated taillights of the leading vehicle and a front-facing camera of the follower is utilized to transmit a verification key. In the footage of the receiving camera, both the transmitted verification key and the transmitting vehicle are visible and can be associated. If the car in front is able to transmit a valid verification key, the platoon can be built. In this article, a comprehensive evaluation of vehicular OCC is presented. The system is tested in different configurations on public roads with various environmental conditions. This platoon verification mechanism takes less than 10 seconds, even in challenging conditions, e.g., in rain, darkness, or low sun. The experiments demonstrate that modern vehicles are equipped with all hardware components required to implement this OCC system by using the built-in front camera of a Tesla Model 3 as receiver without any modifications.
An important development direction for the future of the automotive industry is connected and cooperative vehicles. Some functionalities in traffic need the cars to communicate with each other. In platooning, multiple cars driving in succession reduce the distances between them to drive in the slipstream of each other to reduce drag, energy consumption, emissions, and the probability of traffic jams. The car in front controls the car behind remotely, so all cars in the platoon can accelerate and decelerate simultaneously. In this paper, a system for vehicle-to-vehicle communication is proposed using modulated taillights for transmission and an off-the-shelf camera with CMOS image sensor for reception. An Undersampled Differential Phase Shift On–Off Keying modulation method is used to transmit data. With a frame sampling rate of 30 FPS and two individually modulated taillights, a raw data transmission rate of up to 60 bits per second is possible. Of course, such a slow communication channel is not applicable for time-sensitive data transmission. However, the big benefit of this system is that the identity of the sender of the message can be verified, because it is visible in the captured camera image. Thus, this channel can be used to establish a secure and fast connection in another channel, e.g., via 5G or 802.11p, by sending a verification key or the fingerprint of a public key. The focus of this paper is to optimize the raw data transmission of the proposed system, to make it applicable in traffic and to reduce the bit error rate. An improved modulation mode with smoother phase shifts is used that can reduce the visible flickering when data is transmitted. By additionally adjusting the pulse width ratio of the modulation signal and by analyzing the impact of synchronization offsets between transmitter and receiver, major improvements of the bit error rate (BER) are possible. In previously published research, such a system without the mentioned adjustments was able to transmit data with a BER of 3.46%. Experiments showed that with those adjustments a BER of 0.48% can be achieved, which means 86% of the bit errors are prevented.