Mg and Mg alloys have been studied for almost two centuries; nevertheless, commercial biomedical devices are still not available. The main issue that limits their use in the biomedical field is the rapid degradation rate combined with suitable surface properties. Novel approaches need to be designed for the development of biodegradable Mg-based devices, which could include the use of multifunctional coatings and/or new alloys designed “ad hoc”. The present article reviews on various properties, parameters and improvement methods concerning plasma electrolytic oxidation (PEO) coatings on Mg alloys substrates for biomedical applications. In this regard, (i) optimizing the PEO parameters, (ii) using additives and nanoparticles, (iii) creating combined layers of hard and/or soft particles, (iv) coating the PEO layer with a biodegradable polymer, could be the way to control their degradation rate. The review of recent scientific articles highlights that none of the techniques proposed may be preferred over the others and the need to deepen the studies for allowing the use of Mg-based devices in the biomedical field.
Additive Manufacturing (AM) of polymer composites has enabled the fabrication of highly customized parts with notably mechanical properties, thermal and electrical conductivity compared to un-reinforced polymers. Employing the reinforcements was a key factor in improving the properties of polymers after being 3D printed. However, almost all the existing 3D printing methods could make the most of disparate fiber reinforcement techniques, the fused filament fabrication (FFF) method is reviewed in this study to better understand its flexibility to employ for the proposed novel method. Carbon nanotubes (CNTs) as a desirable reinforcement have a great potential to improve the mechanical, thermal, and electrical properties of 3D printed polymers. Several functionalization approaches for the preparation of CNT reinforced composites are discussed in this study. However, due to the non-uniform distribution and direction of reinforcements, the properties of the resulted specimen do not change as theoretically expected. Based on the phase inversion method, this paper proposes a novel technique to produce CNT-reinforced filaments to simultaneously increase the mechanical, thermal, and electrical properties. A homogeneous CNT dispersion in a dilute polymer solution is first obtained by sonication techniques. Then, the CNT/polymer filaments with the desired CNT content can be obtained by extracting the polymer’s solvent. Furthermore, optimizing the filament draw ratio can result in a reasonable CNT orientation along the filament stretching direction.
The multi‐functionality of polymer matrix composites, proposes remarkable merits over metals including more stiffness and strength, lower weight, higher resistance to corrosion, and fatigue, etc. Furthermore, the next generation of production undergoes a revolution by increasingly progresses in additive manufacturing. There have been a large group of materials that can be exploited for this fashionable fabrication technique, although, polymer matrix composites are a significant class of material that have recently been used in additive manufacturing. The mixture of these polymers with nanofillers such as carbon nanotube improves mechanical, thermal, and electrical conductivity properties. This short review summarizes relevant production techniques, carbon nanotube polymer matrix composites, and performed research on its application for additive manufacturing.
This paper presents a study of the electrical and mechanical properties of polystyrene (PS)/carbon nanotube (CNT) composites prepared using the doctor blade technique. The nanocomposite films of PS/CNT were prepared by casting a composite solution of PS/CNT in tetrahydrofuran (THF) on a glass substrate using a doctor blade and drying in an oven. The nanocomposite films were then characterized using a tensile test and the four-point probe method to evaluate their mechanical properties and electrical conductivity. The experimental results were used to analyze the unpredicted behavior of the nanocomposite films. The experimental results showed that the electrical conductivity of the nanocomposite films became almost insensitive or unmeasurable with increasing CNT content for very dilute PS–THF solutions. In contrast, at higher PS concentrations, film conductivity increased to a given CNT threshold and then decreased. Based on PS–THF viscosity–concentration data, a discussion is elaborated that partially justifies the experimental results.