High-field magnetization of the spin- antiferromagnet was measured in pulsed magnetic fields of up to 56 T in order to study its magnetic phase diagram. When the field was applied along the easy axis (the axis), two distinct transitions were observed at T and T. The former is a spin-flop transition typical for a collinear antiferromagnet and the latter is believed to be a spin-flip transition of canted moments. The canted moments, which are induced by the Dzyaloshinskii-Moriya interactions, anti-align for due to the anisotropic exchange interaction that favors the antiferromagnetic arrangement along the axis. Above , the Zeeman energy of the applied field overcomes the antiferromagnetic anisotropic interaction and the canted moments are aligned along the field direction. Density functional theory was employed to compute the exchange interactions, which were used as inputs for quantum Monte Carlo calculations and then further refined by fitting to the magnetic susceptibility data. Contrary to our previous report in Phys. Rev. B 92, 024423 (2015), the dominant exchange interaction is between the third nearest-neighbor spins, which form zigzag spin chains that are coupled with one another through an intertwining network of the nonnegligible nearest and second nearest-neighbor interactions. In addition, elastic neutron scattering under the applied magnetic fields of up to 10 T reveals the incommensurate helical spin structure in the spin-flop state.
We report the results of magnetization and specific heat measurements of composed of two subsystems A and B, which are magnetically described as an triangular-lattice Heisenberg-like antiferromagnet and a honeycomb-lattice Ising-like antiferromagnet, respectively. These two subsystems were found to be approximately decoupled. undergoes magnetic phase transitions at K and K, which can be interpreted as the orderings of subsystems B and A, respectively. Subsystem A exhibits a magnetization plateau at one-third of the saturation magnetization for the magnetic field perpendicular to the axis owing to the quantum order-by-disorder, whereas for , subsystem B shows three-step metamagnetic transitions with magnetization plateaus at zero, one-third, and one-half of the saturation magnetization. The analysis of the magnetization process for subsystem B shows that the classical ground states at these plateaus are infinitely degenerate within the Ising model.
We report the results of multifrequency high-magnetic-field electron-spin resonance (ESR) measurements on the highly frustrated antiferromagnet . This compound is magnetically composed of two subsystems A and B, which are described as a spin-1/2 triangular-lattice Heisenberg antiferromagnet and a honeycomb-lattice Ising antiferromagnet, respectively. undergoes successive magnetic phase transitions at K and K. For a magnetic field parallel to the axis, subsystem B exhibits successive metamagnetic transitions with magnetization plateaus at one-third and one-half of the saturation magnetization. Below , we observed collective ESR modes for , which are characteristic of a triangular-lattice Heisenberg antiferromagnet with weak easy-plane anisotropy. We also observed a local excitation mode, which can be assigned as a single flip of the Ising-like spin of subsystem B. From a detailed analysis of the collective and local ESR modes, combined with the magnetization process, we determined the magnetic parameters of subsystems A and B, and confirmed that the two subsystems are almost decoupled.
Due to the increasing demand for eco-friendly, inexpensive sound absorbers, this study investigated composites made from recycled paper pulp and urea-formaldehyde adhesive. By varying the pulp contents, five samples from used copy paper and five samples from used corrugated board were fabricated. For the same type of porous absorber, one with a lower bulk density has a higher total porosity, resulting in a higher sound absorption coefficient (SAC) spectrum. Sound-absorbing performance of copy paper composites with bulk densities below 442.4 kg/m3 and corrugated board composites with densities of less than 474.8 kg/m3 can be alternatives to commercial polyurethane foam of the same thickness. The noise reduction coefficient (NRC), as well as the average SAC of all corrugated board composites at medium (αM) and high (αH) frequencies were greater than those of copy paper composites. However, the average SAC at low frequency (αL) was not explicitly different for copy paper and corrugated board composites. In conclusion, corrugated board composites are a better candidate as sound absorbers than copy paper composites with the same pulp content.