Research Center for Radioactive Waste Technology (PRTLR), Nuclear Power Research Organization (OR TN), National Research and Innovation Agency (BRIN), Indonesia
Dr. Ratiko Ratiko
Research Center for Radioactive Waste Technology (PRTLR), Nuclear Power Research Organization (OR TN), National Research and Innovation Agency (BRIN), Indonesia
This study proposes a method of optimizing the dry storage design for nuclear-spent fuel from the G.A. Siwabessy research reactor at National Nuclear Energy Agency of Indonesia (BATAN). After several years in a spent fuel pool storage (wet storage), nuclear spent fuel is often moved to dry storage. Some advantages of dry storage compared with wet storage are that there is no generation of liquid waste, no need for a complex and expensive purification system, less corrosion concerns and that dry storage is easier to transport if in the future the storage needs to be sent to the another repository or to the final disposal. In both wet and dry storage, the decay heat of spent fuel must be cooled to a safe temperature to prevent cracking of the spent fuel cladding from where hazardous radioactive nuclides could be released and harm humans and the environment. Three optimization scenarios including the thermal safety single-objective, the economic single-objective and the multi-objective optimizations are obtained. The optimum values of temperature and cost for three optimization scenarios are 317.8K (44.7°C) and 11638.1 US$ for the optimized single-objective thermal safety method, 337.1K (64.0°C) and 6345.2 US$ for the optimized single-objective cost method and 325.1K (52.0°C) and 8037.4 US$ for the optimized multi-objective method, respectively.
A key issue contributing to the success of NPP technology is the safe handling of radioactive waste, particularly spent nuclear fuel. According to the IAEA safety standard, the spent fuel must be stored in interim wet storage for several years so the radiation and the decay heat of the spent fuel will decrease to the safe limit values, after which the spent fuel can be moved to dry storage. In this study, we performed a theoretical analysis of heat removal by natural convection airflow in spent nuclear fuel dry storage. The temperature difference between the air inside and outside dry storage produces an air density difference. The air density difference causes a pressure difference, which then generates natural airflow. The result of the theoretical analysis was validated with simulation software and experimental investigation using a reduced-scale dry storage prototype. The dry storage prototype consisted of a dry cask body and two canisters stacked to store materials testing reactor (MTR) spent fuel, which generates decay heat. The cask body had four air inlet vents on the bottom and four air outlet vents at the top. To simulate the decay heat from the spent fuel in the two canisters, the canisters were wrapped with an electric wire heater that was connected to a voltage regulator to adjust the heat power. The theoretical analysis results of this study are relatively consistent with the experimental results, with the mean relative deviation (MRD) values for the prediction of air velocity, the heat rate using natural airflow, and the heat rate using the thermal resistance network equation are +0.76, −23.69, and −29.54%, respectively.
27 October 2015 in International Journal of Technology
PENGARUH PERISAI RADIASI PADA PENYIMPANAN KERING BAHAN BAKAR NUKLIR BEKAS UNTUK REAKTOR DAYA EKSPERIMENTALDi masa mendatang, Badan Tenaga Nuklir Nasional (BATAN) berencana membangun Reaktor Daya Eksperimental (RDE) dengan daya termal 10 MW. RDE merupakan merupakan reaktor suhu tinggi dengan bahan bakar berupa pebble yang teknologinya mirip dengan reaktor HTR-10. Dalam operasional RDE hal yang perlu diperhatikan adalah pengelolaan Bahan Bakar Nuklir Bekas (BBNB). Oleh karena itu, teknologi pengelolaan BBNB HTR-10 dapat digunakan sebagai acuan dalam pengelolaan BBNB reaktor RDE. Pengelolaan BBNB reaktor HTR-10 disimpan dalam tangki penyimpanan dengan sistem kering. Telah dilakukan perhitungan laju dosis pada tangki penyimpanan BBNB di gedung reaktor dan interim storage menggunakan Monte Carlo N-Particle 5 (MCNP-5). Hasil perhitungan laju dosis pada tangki penyimpanan dengan berbagai ketebalan timbal (Pb) berkisar 11,7 – 2,560 x 106 µSv/jam dan 813,06 – 7,146 x 106 µSv/jam masing-masing pada gedung reaktor dan interim storage. Hal ini menunjukkan bahwa ketebalan Pb pada tangki penyimpanan tidak memberikan pengaruh yang signifikan dalam penurunan laju dosis baik pada gedung reaktor maupun interim storage. Penurunan laju dosis akan lebih efektif dengan penambahan Pb pada shielding luar tangki penyimpanan BBNB. Hasil perhitungan laju dosis berkisar 2,560 x 106 – 20,32 µSv/jam dan 7,146 x 106 – 105,58 µSv/jam untuk berbagai ketebalan Pb pada shielding luar tangki penyimpanan BBNB masing-masing di gedung reaktor maupun interim storage. Meskipun nilai laju dosis tidak memenuhi syarat Nilai Batas Dosis (NBD) bagi pekerja radiasi dan masyarakat, namun untuk keselamatan pekerja radiasi penanganan BBNB ini dapat diakomodir dengan konsep As Low As Resonably Achievable (ALARA), memperpanjang waktu peluruhan BBNB dan menfungsikan dinding interim storage sebagai shielding. Kata kunci : Reaktor Daya Eksperimental (RDE), Bahan Bakar Nuklir Bekas (BBNB), laju dosis, perisai radiasi.