The study focuses on testing a simplified way of estimating the resultant force due to ballistic impacts resulting in a full fragmentation of the impactor with no penetration of the target. The method is intended to be useful for the parsimonious structural assessment of military aircrafts with integrated ballistic protection systems by means of large scale explicit finite element simulations. The research investigates the effectiveness of the method in allowing the prediction of the fields of plastic deformation collected by hard steel plates impacted by a wide range of semi-jacketed, monolithic, and full metal jacket .308 Winchester rifle bullets. The outcomes show the effectiveness of the method being strictly related to the full compliance of the considered cases with the bullet-splash hypotheses. The study therefore suggests the application of the load history approach only after careful experimental investigations on the specific impactor–target interactions.
An original simplified finite element model is proposed to simulate the effects of non-penetrating ballistic impacts causing the so-called bullet splash phenomenon (complete bullet fragmentation), while no fragmentation is caused to the target. The model is based on the Arbitrary Lagrangian Eulerian formulation (ALE) and it simulates the impact as a fluid-structure interaction. The bullet splash phenomenon has been tested by experimental analyses of AISI 304L plates impacted by 9x21 FMJ (full metal jacket) bullets. The model has been developed with the aim of creating a simplified approach to be used in the industry and forensic sciences to simulate the non-penetrating interaction of soft impactors with hard targets. Comparisons between evidence and simulation results lead to the conclusion that the proposed approach can be used in a conservative way to estimate both local and global effects of bullet-splash phenomena.
This paper presents the results of the numerical simulation of the 1993 terrorist attack at the New York World Trade Center. Aim of this work is to compare the results of the simulation with the actual damage suffered by the structure, in order to discuss and explore the possibility of extending the use of such simulation tools (widely used for industrial products) also to the design and optimization of large structures.The work involves the state of art in numerical simulation (based on finite elements method) coupled with modeling the high strain-rate effect on mechanical behavior of materials.The results show a strong concordance with the historical data of the event. This leads tohypothesize future scenarios (even normative ones) in the field of large structures design and safety improvement against impulsive events.
1 October 2022 in Fracture and Structural Integrity
An original simplified formula is proposed to estimate the load history caused by ballistic impacts characterized by the so-called bullet splash phenomenon, consisting in the complete bullet fragmentation with no penetration of the target. The formula is based on the progressive momentum variation of the mass of the bullet impacting on a planar plate normal to the impact direction. The method aims at creating a simplified approach to assess the response of structures by means of explicit finite element simulations without the need of modelling the interaction between impactor and target. The results demonstrate that the proposed method can be used to estimate the forces generated by bullet-splash phenomena of 9x21mm full metal jacket bullets and effectively applied to finite element simulations allowing significant reductions in computational cost.
11 September 2014 in Materials Performance and Characterization
Based on numerical and experimental data, an FEM model was implemented to simulate quench treatments on large forging components. After experimental validation of convection coefficient laws between water and component surface, time–temperature curves were determined for a large forged piece for different corss section of the component itself. Then superimposing these curves to the continuous cooling transformation diagram for the material, it was possible to identify the microstructural constituents of the steel after quenching. The component residual stress field was obtained by implementing the volumetric expansion law due to the phase transition during cooling. The ability to simulate the heat treatment of heavy size parts must be considered very useful due to quickly managing of all variables that govern the problem (initial and final temperatures, holding times, quenching mode, size, and geometry of components) and the possibility to predict final characteristics of the workpiece.