We have investigated the aging processes in InGaN laser diodes fabricated by metal organic vapor phase epitaxy on low-dislocation-density, high-pressure-grown bulk gallium nitride crystals. The measured threshold current turned out to be a square root function of aging time, indicating the importance of diffusion for device degradation. The differential efficiency, in contrast, was roughly constant during these experiments. From these two observations we can conclude that the main reason for degradation is the diffusion-enhanced increase of nonradiative recombination within the active layer of the laser diode. Additionally, microscopic studies of the degraded structures did not reveal any new dislocations within the active area of the aged diodes, thus identifying point defects as a source of nonradiative processes.

InGaN-GaN multiple-quantum-well (MQW)-based photodetectors, with a detection edge at 450 nm and a high responsivity, have been fabricated and characterized. We show that the performance of MQW-based photodetectors strongly depends on a proper device design, i.e., number of QWs, and barrier and blocking layer thickness and doping level. Namely, the responsivity can be varied in the ~ 1 to ~ 100 mA/W range in similar structures and with the same number of QWs. These results support a model where the photocurrent increase is due to the improvement of collection efficiency caused by a change in transport mechanism for carriers photogenerated in the QWs. The transport mechanism depends on the location of the QWs in relation to the depletion region.

The low-temperature breakdown of the electroluminescence intensity (ELI) of blue/violet InGaN-based light-emitting diodes (LEDs) is shown to be independent of the structural details of the LED active region. Instead, the presence of an electron blocking layer (EBL) plays a decisive role. The authors attribute the ELI collapse to the low-temperature hole-blocking properties of the EBL. However, removing the EBL leads to a much reduced ELI because of a disproportional increase of electron overflow processes, which shows that the presence of an EBL in blue/violet InGaN-based LEDs is still essential. Optimization of the EBL by means of Mg doping is discussed.

In the present study, the electrical and optical properties of deep defects in p-i-n GaN junction and AlGaN/GaN heterojunction are investigated by means of the deep level transient spectroscopy (DLTS), Laplace DLTS, and electroluminescence (EL) techniques. We demonstrate that in both structures the yellow luminescence (YL) is a dominant band in the EL spectra recorded at room temperature. We correlate the YL band with the minority DLTS peaks observed at about 370 K. A gallium vacancy-related defect seems to be a probable candidate as to the origin of the defect. Another dominant majority peak observed in the DLTS studies was concluded to be linked with a donor-like defect in the upper half of the bandgap. The origin of the defect is discussed.

The microstructural evolution of InGaN/GaN multiple quantum wells grown by metalorganic chemical vapor phase epitaxy was studied as a function of the growth temperature of the GaN quantum barriers (QBs). We observed the formation of basal stacking faults (BSFs) in GaN QBs grown at low temperature. The presence of BSFs terminated by stacking mismatch boundaries (SMBs) leads to the opening of the structure at the surface into a V-shaped trench loop. This trench may form above an SMB, thereby terminating the BSF, or above a junction between the SMB and a subsequent BSF. Fewer BSFs and thus fewer trench defects were observed in GaN QBs grown at temperatures higher than 830 °C. Further increase in the growth temperature of the GaN QBs led to the suppression of the threading dislocation opening into V-pits.