A novel three-dimensional metal–organic framework (MOF) based on the biocompatible/bioactive, earth-abundant calcium and the photoactive triazine triphosphonate ligand has been hydrothermally synthesised and fully characterised (XRD, FTIR, TGA, SEM, etc.). Denoted as IEF-32 (IEF stands for the IMDEA Energy Framework), its crystal structure was unveiled by single-crystal X-ray diffraction, exhibiting free P–OH groups in two coordination modes (–PO3H2 and –PO3H) and acid unsaturated metal sites. This robust structure shows high thermal and chemical stability (in several catalytically-relevant organic solvents and water, pH = 3 to 12). Furthermore, this study presents the first proof of concept for employing a Ca phosphonate MOF as an antifungal and preservative agent in active packaging. Specifically, IEF-32 effectively preserved grapes, extending their shelf life to one month under fungal spoilage and ripening conditions (relative humidity 80%, 21 °C) while retaining its structural and chemical integrity. Finally, in vitro studies confirmed the biosafety of IEF-32 in intestinal and pulmonary cells, opening new avenues for the implementation of Ca-based P-MOFs in sustainable food preservation technologies.
Upon depolarization of chromaffin cells (CCs), a prompt release of catecholamines occurs. This event is triggered by a subplasmalemmal high-Ca2+ microdomain (HCMD) generated by Ca2+ entry through nearby voltage-activated calcium channels. HCMD is efficiently cleared by local mitochondria that avidly take up Ca2+ through their uniporter (MICU), then released back to the cytosol through mitochondrial Na+/Ca2+ exchanger (MNCX). We found that newly synthesized derivative ITH15004 facilitated the release of catecholamines triggered from high K+-depolarized bovine CCs. Such effect seemed to be due to regulation of mitochondrial Ca2+ circulation because: (i) FCCP-potentiated secretory responses decay was prevented by ITH15004; (ii) combination of FCCP and ITH15004 exerted additive secretion potentiation; (iii) such additive potentiation was dissipated by the MICU blocker ruthenium red (RR) or the MNCX blocker CGP37157 (CGP); (iv) combination of FCCP and ITH15004 produced both additive augmentation of cytosolic Ca2+ concentrations ([Ca2+]c) K+-challenged BCCs, and (v) non-inactivated [Ca2+]c transient when exposed to RR or CGP. On pharmacological grounds, data suggest that ITH15004 facilitates exocytosis by acting on mitochondria-controlled Ca2+ handling during K+ depolarization. These observations clearly show that ITH15004 is a novel pharmacological tool to study the role of mitochondria in the regulation of the bioenergetics and exocytosis in excitable cells.
Interface engineering is a powerful tool for enhancing electron/hole transfer and extraction, as well as reducing charge carrier recombination in perovskite-based optoelectronic devices, including light-emitting diodes (LEDs) and photovoltaic (PV) devices. Here, incorporating an interlayer between the perovskite and charge transport layers has been an extremely successful approach to fine-tune energy level alignment, boosting device performance. In this work, we investigate the incorporation of bismuth-based perovskitoids as interlayers to deepen the position of the perovskite’s conduction band. Our results clearly show that perovskite solar cells based on a PIN architecture with a triple-cation composition (TC) incorporating the bismuth-based interlayer outperform those without when using C60-fullerene (C60) as the electron charge extraction layer. We attribute this improvement to the deepening of the conduction band position by approximately 0.5 eV, which agrees with the X-ray photoelectron spectroscopy (XPS) and ultraviolet photoelectron spectroscopy (UPS) measurements. These findings demonstrate the potential of Bi-based perovskitoid as interlayers to induce band bending in the perovskite layer, effectively allowing fine-tuning of the energy level alignment at the device interfaces, thereby paving the way for future optoelectronic technologies.