Additive manufacturing is an attractive technology due to its versatility in producing parts with diverse properties from a single material. However, the process often generates plastic waste, particularly from failed prints, making sustainability a growing concern. Recycling this waste material presents a potential solution for reducing environmental impact while creating new, functional parts. In this study, the feasibility of creating printable filaments from recycled polylactic acid (PLA) waste and virgin PLA pellets was explored. Filaments were manufactured in the lab using a single-screw desktop extruder with four temperature zones, with compositions ranging from 100% virgin PLA to 100% recycled PLA in 10% composition increments. Test samples were 3D printed using a Material Extrusion 3D printer and subjected to tensile testing in conjunction with digital image correlation to evaluate their ultimate tensile strength, yield strength, Young’s modulus, ductility, toughness, and strain distribution. The results indicated that the optimal mechanical properties were observed in specimens made from 100% virgin PLA, 100% recycled PLA, and a 50% virgin/50% recycled PLA blend. Additionally, comparisons with a commercially produced PLA filament revealed that 100% virgin and 100% recycled blends have a 50.33% and 48% higher tensile strength than commercial filament, respectively. However, commercial filaments exhibited higher ductility and toughness than the lab-made extruded filament.
The current work investigates the micro- and macrostructural integrity of layered structures of 17-4PH stainless steel powders manufactured using direct metal laser sintering (DMLS). More specifically, a vacuum solid-state sintering method accompanied with a powder layering process has been employed. Tensile specimens manufactured according to standard ASTM E8 using additive manufacturing were grown at different orientations so as to realize their effect on the overall microstructural integrity. The 40-μm-thick parts were manufactured using a 500 W laser beam to sinter the powder in a vacuum and nitrogen atmosphere. Melt pools were controlled by limiting the laser intensity to 65% and the focal length range was adjusted between 3.4 and 4.6 mm to control the induced spark and reduce oversintering of the powdered layer. The tensile properties and density as well as micro- and macrohardness for the manufactured samples have been measured and analyzed. Furthermore, microstructural analysis of the undeformed and fracture surfaces of the layered 17-4PH stainless steel made by the DMLS process was conducted by means of X-ray diffraction, optical microscopy, and scanning electron microscope. Moreover, a comparative analysis with traditionally manufactured samples was carried out to set a benchmark for the use of additively manufactured stainless steel. The horizontally grown tensile specimens seemed to yield better results than diagonally grown specimens; however, the wrought specimens seemed to supersede both in terms of mechanical properties.