Triply periodic minimum surface (TPMS)-based lattice structures have gained interest for their outstanding capacity to absorb energy, their high load-bearing capacity, and their high surface-to-volume ratio. This study considered three TPMS cell topologies, including Diamond, Gyroid, and Primitive. The FDM process was used to print the lattice structures with two materials: pure polylactic acid (PLA) and carbon fiber-reinforced PLA (PLA + CF). The influence of carbon fiber (CF) incorporation, unit cell type (topologies) and size, and relative density (RD) on mechanical properties and failure patterns were explored comprehensively under uniaxial compression testing. The results demonstrate a change in the compressive modulus (0.09 to 0.47 GPa), compressive strength (2.98 to 13.89 MPa), and specific energy absorption (SEA) (0.14 MJ/m3/g to 0.58 MJ/m3/g) due to the influence of CF incorporation, cell type and size, and RD. Results indicate that the Diamond structure outperformed both Primitive and Gyroid structures in terms of compressive modulus and strength, and SEA. All the CF-based TPMS structures showed a higher compressive modulus. Compressive strength and energy absorption capacity were both slightly enhanced in most PLA + CF-based Diamond structures. On the contrary, Gyroid and Primitive structures showed better performance for pure PLA-based structures in terms of compression strength and specific absorption energy.
21 January 2019 in International Journal of Precision Engineering and Manufacturing-Green Technology
Titanium and its alloys especially Ti-6Al-4V are being widely used numerous application areas. In addition to have iconic properties, Ti-6Al-4V is considered as challenging material in machining perspective that is why it has captured global research focus. In this research, electric discharge machining of Ti-6Al-4V has been carried out by employing four different types of electrode materials (graphite, aluminum, copper, and brass) assigned with two alternate polarities (positive and negative). Selection of the most appropriate tool material and electrode polarity is the important aspect needed to be explored for this alloy. In addition to polarity, discharge current, and pulse time ratio have been considered as process variables owing to have their direct influence in electric discharge machining. Taguchi L9 array has been employed for each of the four electrodes with positive polarity and similarly L9 with negative polarity. Thus, a total number of 72 experiments have been conducted. Tool wear rate and overcut (OC) around the machined surfaces are the response characteristics to be investigated in order to achieve minimum amounts of both of these two responses. Selection of the most suitable tool with common tool polarity has been carried out meeting the decision criteria of minimum tool wear and minimum OC.