Se Hyeon Jeong

Ms. Se Hyeon Jeong


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
DKDong Min Kim
Dong Min Kim
SHSoon Ho Hong
Soon Ho Hong
SJSe Hyeon Jeong
Se Hyeon Jeong
SKSun Je Kim
Sun Je Kim
The interest in wind-assisted ship propulsions (WASPs) is increasing to improve fuel efficiency and to reduce greenhouse gas emissions in ships. A rotor sail, one of the typical WASPs, can provide auxiliary propulsive force by rotating a cylinder-shaped structure based on the Magnus effect. However, due to its huge rotating structure, a meticulous evaluation of the influence on the ship structure and dynamical stability of the rotating structure should be conducted in the design stage. In this respect, an analysis of the rotating structure for a 30 m height and 3 m diameter rotor sail was conducted in this study. First, a 4DOF (four-degree-of-freedom) model was derived to simplify the dynamics of the rotor sail. Using the 4DOF model, natural frequencies for four low-order modes of the rotor sail were calculated, and frequency responses at support points were predicted. Next, a comparison and validation with the finite element model of the rotor sail were carried out. For the 1st and 2nd natural frequencies, a difference of approximately 0.3 Hz was observed between the 4DOF model and the finite element model, confirming the effectiveness of the 4DOF model for low-order modes. In analysis with changes in the bearing supporting stiffnesses, it was verified that lower support bearings have a significant impact on rotor dynamics compared to upper support bearings. Vibration response at the upper support was also confirmed through frequency response analysis caused by imbalance at Thom disk and mid-plate. Additionally, when estimating the eccentricity of the Thom disk as imbalance, a limit of eccentricity error could be set as 24 mm. The presented modeling procedures and analysis results can be references during early design stage of a novel rotor sail structure.

Verified
Journal Article
Open access
PDF file
SKSeong Hyeon Kim
Seong Hyeon Kim
HSHyun Min Song
Hyun Min Song
SJSe Hyeon Jeong
Se Hyeon Jeong
WLWon Joon Lee
Won Joon Lee
SKSun Je Kim
Sun Je Kim
Rotating machinery is essential in various industrial fields, and growing demands for high performance under harsh operating conditions have heightened interest in fault diagnosis and prognostic technologies. However, a major challenge in fault diagnosis research lies in the scarcity of data, primarily due to the inability to deliberately introduce faults into machines during actual operation. In this study, a physical model is proposed to realistically simulate the system behavior of a ship’s turbo-rotating machinery by coupling the torsional and lateral vibrations of the rotor. While previous studies employed simplified single-shaft models, the proposed model adopted gear mesh interactions to reflect the coupling behavior between shafts. Furthermore, the time-domain response of the system is analyzed through state-space transformation. The proposed model was applied to simulate imbalance and gear teeth damage conditions that may occur in marine turbo-rotating systems and the results were compared with those under normal operating conditions. The analysis confirmed that the model effectively reproduces fault-induced dynamic characteristics. By enabling rapid implementation of various fault conditions and efficient data acquisition data, the proposed model is expected to contribute to enhancing the reliability of fault diagnosis and prognostic research.