To develop an advanced high strength steel with reasonable ductility based on low alloying concept as well as micro-composite microstructure essentially consisting of bainite, martensite and retained austenite, a Si-bearing, low alloy medium carbon sheet steel (DIN1.5025 grade) was subjected to typical quenching and bainitic holding (Q&B) type isothermal treatment in the bainitic region close to martensite start temperature (Ms) for different durations in the range 5s to 1h. While the low temperature bainite has the potential to provide the required high strength, a small fraction of finely divided austenite stabilized between the bainitic laths is expected to provide the desired elongation and improved work hardening. Various materials characterization techniques including conventional light metallography, field emission scanning electron microscopy FE-SEM, electron backscatter diffraction (EBSD), differential thermal analysis, X-ray diffraction (XRD) and vibrating sample magnetometry (VSM), were used to detect and estimate the volume fraction, size and morphology and distribution of retained austenite in the micro-composite samples. The results showed that the color light metallography technique using LePera’s etching reagent could clearly reveal the retained austenite in the microstructures of the samples isothermally held for shorter than 30s, beyond which an unambiguous distinction between the retained austenite and martensite was imprecise. On the contrary, the electron microscopy using a FE-SEM was not capable of identifying clearly the retained austenite from bainite and martensite. However, the EBSD images could successfully distinguish between bainite, martensite and retained austenite microphases with good contrast. Although the volume fractions of retained austenite measured by EBSD are in accord with those obtained by XRD and color light metallography, the XRD measurements showed somewhat higher fractions owing to its ability to acquisition and analyze the diffracted X-rays from very finely divided retained austenite, too. The differential thermal analysis and vibrating sample magnetometry techniques also confirmed the stabilization of retained austenite finely divided in bainite/martensite micro-composite microstructures. In addition, the peak temperatures and intensities corresponding to the decomposition of retained austenite were correlated with the related volume fractions and carbon contents measured by the XRD analysis.
17 August 2023 in Journal of Materials Research and Technology
This work deals with the kinetic aspects of bainite formation during isothermal holding above and below the martensite start (Ms~275 °C) temperature using a low-alloy, high-silicon DIN 1.5025 steel in a range suitable for achieving ultrafine/nanostructured bainite. Dilatation measurements were conducted to study transformation behaviour and kinetics, while the microstructural features were examined using laser scanning confocal microscopy and electron backscatter diffraction (EBSD) techniques combined with hardness measurements. The results showed that for isothermal holding above the Ms temperature, the maximum bainitic transformation rate decreased with the decrease in isothermal holding temperature between 450 and 300 °C. On the other hand, for isothermal holding below the Ms temperature at 250 and 200 °C, the maximum rate of transformation was achieved corresponding to region I due to the partitioning of carbon and also possibly because of the ledged growth of isothermal martensite soon after the start of isothermal holding. In addition, a second peak was obvious at about 100 and 500 s, respectively, during holding at 250 and 200 °C due to the occurrence of bainitic transformation, marking the beginning of region II.
11 February 2025 in Journal of Materials Research and Technology