Objective: Novel developments in the robotics field have produced systems that can support person wheelchair transfers, maximize safety and reduce caregiver burden. The purpose of this study was to identify and describe these systems, their usability (or satisfaction), the context for which they have been or can be used and how they have been evaluated to determine evidence for their effectiveness. Method: Available research on Person Transfer Assist Systems (PTAS) was systematically gathered using similar standards to the PRISMA guidelines. The search terms were derived from common terms and via exploring similar review articles. Initial search terms displayed 1330 articles and by using the inclusion/exclusion criteria 96 articles were selected for abstract review. After full- text reviewing 48 articles were included. Results: 29 articles concerned research in robotic transfer systems, 10 articles used both ceiling and floor-mounted lifts and 9 articles used only floor-mounted lifts as an intervention/control group. The results of this analysis identified a few usability evaluations for robotic transfer prototypes, especially ones comparing prototypes to existing marketed devices. Conclusion: Robotic device research is a recent development within assistive technology. Whilst usability evaluations provided evidence that a robotic device will provide better service to the user, the sample number of subjects used are minimal in comparison to any of the intervention/control group articles. Experimental studies between PTASs are required to support technological advancements. Caregiver injury risk has been the focus for most of the comparison articles; however, few articles focus on the implications to the person.
3 August 2023 in Transportation Research Record: Journal of the Transportation Research Board
This study aimed to apply a journey mapping methodology to identify travel considerations and barriers for people with disabilities (PWDs) at each travel stage, from considering a trip through to arriving at the destination for their current modes of transportation, with the objective of understanding and avoiding “pain points” during a transition to autonomous driving systems. Twenty PWDs, including those with physical, visual, aural, cognitive, and combined physical/visual impairments, participated in a semistructured one-on-one interview. Descriptive statistics were used for demographic information, and qualitative content analysis was used to analyze the transcribed interviews and extract themes. Themes were further organized by the modes of transportation used. The top four themes in considering and planning a trip were third-party assistance availability (private vehicle, public transportation, and paratransit), finding an accessible or suitable parking space (private vehicle), access to a service location (public transportation and paratransit), and transportation schedules (public transportation and paratransit). The top four travel barriers to locating, entering, riding, and exiting transportation and arriving at the destination were vehicle ingress/egress (private vehicle and public transportation), concerns about wheelchair securement (public transportation and paratransit), requiring third-party assistance (private vehicle and public transportation), and accessibility to service locations (public transportation). The study suggests that to mitigate travel considerations and barriers for PWDs, vehicle-specific barriers and infrastructure issues should be addressed simultaneously. We anticipate that the findings will provide insights into the design and development of autonomous vehicles, to better accommodate the needs of PWDs.
Wheelchair users are exposed to whole-body vibration (WBV) when driving on sidewalks and in urban environments; however, there is limited literature on WBV exposure to power wheelchair users when driving during daily activities. Further, surface transitions (i.e., curb-ramps) provide wheelchair accessibility from street intersections to sidewalks; but these require a threshold for water drainage. This threshold may induce high WBV (i.e., root-mean-square and vibration-daily-value accelerations) when accessibility guidelines are not met. This study analyzed the WBV effects on power wheelchairs with passive suspension when driving over surfaces with different thresholds. Additionally, this study introduced a novel power wheelchair with active suspension to reduce WBV levels on surface transitions. Three trials were performed with a commercial power wheelchair with passive suspension, a novel power wheelchair with active suspension, and the novel power wheelchair without active suspension driving on surfaces with five different thresholds. Results show no WBV difference among EPWs across all surfaces. However, the vibration-dose-value increased with higher surface thresholds when using the passive suspension while the active suspension remained constant. Overall, the power wheelchair with active suspension offered similar WBV effects as the passive suspension. While significant vibration-dose-value differences were observed between surface thresholds, all EPWs maintained WBV values below the ISO 2631-1 health caution zone.
Tips and falls are the most prominent causes of wheelchair accidents that occur when driving on uneven terrains and less accessible environments. The Mobility Enhancement Robotic Wheelchair (MEBot) was designed to improve the stability of Electric Powered Wheelchairs (EPW) when driving over these environments. MEBot offers six independently height-adjustable wheels to control attitude of its seat over uneven and angled terrains. Its attitude control application uses an inertial measurement unit to detect seat angles changes to adjust each wheel-height accordingly. MEBot was compared to commercial EPWs in terms of EPW performance (seat angle changes and response time) and participant perception (satisfaction and task-load demand) towards each device. Ten participants drove their own EPW and MEBot for five trials each through driving tasks that replicated outdoor environments. Results showed less change in the pitch angle when driving up and down a 10° slope using MEBot (5.6 ± 1.6°, 6.6 ± 0.5°) compared to the participants’ own EPW (14.6 ± 2.6°, 12.1 ± 2.6°). However, MEBot required 7.8 ± 3.0 seconds to self-adjust to the minimum angle when driving over the tasks. Participants reported no difference in satisfaction and task load demand between EPWs due to similarities in comfort and ease-of-use. Improving the speed and efficiency of MEBot’s attitude control application will be addressed in future work based upon participants’ feedback.
7 August 2023 in Disability and Rehabilitation: Assistive Technology
Existing automated vehicle transportation guidelines and regulations have minimal guidance to address the specific needs of people with disabilities. Accessibility should be at the forefront to increase autonomy and independence for people with disabilities. The purpose of this research is to better understand potential facilitators and barriers to using accessible autonomous transportation. Focus groups were conducted with key stakeholders derived from people with disabilities (n = 5), travel companions/caregivers (n = 5), and transportation experts or designers (n = 11). The themes include describing stakeholder perceptions across all three groups by identified themes: autonomous vehicle assistive technology, autonomy vs automation, cost, infrastructure, safety & liability, design challenges, and potential impact. Specific gaps and needs were identified regarding barriers and facilitators for transportation accessibility and evidence-based guidance. These specific gaps can help to formulate design criteria for the communication between, the interior and exterior of accessible autonomous vehicles.