Formamidinium lead iodide (FAPbI 3 ) can exhibit polymorphism at ambient conductions. Three different structural configurations and their thermally activated phase transitions are identified by temperature dependent micro-Raman spectroscopy.
Atmospheric pressure plasma jets (APPJ) are widely used in industry for surface cleaning and chemical modification. In the recent past, they have gained more scientific attention especially in the processing of carbon nanomaterials. In this work, a novel power generation technique was applied to realize the stable discharge in N2 (10 vol.% H2) forming gas in ambient conditions. This APPJ was used to reduce solution-processed graphene oxide (GO) thin films and the result was compared with an established and optimized reduction process in a low–pressure capacitively coupled (CCP) radiofrequency (RF) hydrogen (H2) plasma. The reduced GO (rGO) films were investigated by Raman spectroscopy and X-ray photoelectron spectroscopy (XPS). Effective deoxygenation of GO was observed after a quick 2 s treatment by AAPJ. Further deoxygenation at longer exposure times was found to proceed with the expense of GO–structure integrity. By adding acetylene gas into the same APPJ, carbon nanomaterials on various substrates were synthesized. The carbon materials were characterized by Raman spectroscopy, scanning electron microscopy (SEM), and energy-dispersive X-ray (EDX) analyses. Fullerene-like particles and graphitic carbon with short carbon nanotubes were detected on Si and Ag surfaces, respectively. We demonstrate that the APPJ tool has obvious potential for the versatile processing of carbon nanomaterials.
28 December 2023 in Advanced Energy and Sustainability Research
Nickel oxide (NiO1+δ) is a versatile material used in various fields such as optoelectronics, spintronics, electrochemistry, and catalysis which is prepared with a wide range of deposition methods. Herein, for the deposition of NiO1+δ films, the reactive gas flow sputtering (GFS) process using a metallic Ni hollow cathode is developed. This technique is distinct and has numerous advantages compared to conventional sputtering methods. The NiO1+δ films are sputtered at low temperatures (100 ºC) for various oxygen partial pressures during the GFS process. Additionally, Cu‐incorporated NiO1+δ (CuxNi1−xO1+δ) films are obtained with 5 and 8 at% Cu. The thin films of NiO1+δ are characterized and evaluated as a hole‐transporting layer (HTL) in perovskite solar cells (PSCs). The NiO1+δ devices are benchmarked against state‐of‐the‐art self‐assembled monolayers (SAM) ([2‐(3,6‐dimethoxy‐9H‐carbazol‐9‐yl)ethyl]phosphonic acid (also known as MeO2PACz)‐based PSCs. The best‐performing NiO1+δ PSC achieves an efficiency (η) of ≈16% without a passivation layer at the HTL interface and demonstrates better operational stability compared to the SAM device. The findings suggest that further optimization of GFS NiO1+δ devices can lead to higher‐performing and more stable PSCs.