In the case of infinite plane-parallel single- and double-layered cloud, the solar irradiance at ground level computed by a radiative transfer model can be approximated by the product of the irradiance under clear atmosphere and a modification factor due to cloud properties and ground albedo only. Changes in clear-atmosphere properties have negligible effect on the latter so that both terms can be calculated independently. The error made in using this approximation depends mostly on the solar zenith angle, the ground albedo and the cloud optical depth. In most cases, the maximum errors (95th percentile) on global and direct surface irradiances are less than 15 W m−2 and less than 2–5% in relative value. These values are similar to those recommended by the World Meteorological Organization for high-quality measurements of the solar irradiance. Practically, the results mean that a model for fast calculation of surface solar irradiance may be separated into two distinct and independent models, possibly abacus-based, whose input parameters and resolutions can be different, and whose creation requires less computation time and resources than a single model.
The worldwide growing development of PV capacity requires an accurate forecast for a safer and cheaper PV grid penetration. Solar energy variability mainly depends on cloud cover evolution. Thus, relationships between weather variables and forecast uncertainties may be quantified to optimize forecast use. An intraday solar energy forecast algorithm using satellite images is fully described and validated over three years in the Paris (France) area. For all tested horizons (up to 6 h), the method shows a positive forecast skill score compared to persistence (up to 15%) and numerical weather predictions (between 20% and 40%). Different variables, such as the clear-sky index (Kc), solar zenith angle (SZA), surrounding cloud pattern observed by satellites and northern Atlantic weather regimes have been tested as predictors for this forecast method. Results highlighted an increasing absolute error with a decreasing SZA and Kc. Root mean square error (RMSE) is significantly affected by the mean and the standard deviation of the observed Kc in a 10 km surrounding area. The highest (respectively, lowest) errors occur at the Atlantic Ridge (respectively, Scandinavian Blocking) regime. The differences of relative RMSE between these two regimes are from 8% to 10% in summer and from 18% to 30% depending on the time horizon. These results can help solar energy users to anticipate—at the forecast start time and up to several days in advance—the uncertainties of the intraday forecast. The results can be used as inputs for other solar energy forecast methods.
6 September 2019 in Geoscientific Model Development
Numerical weather prediction models tend to underestimate cloud presence and therefore often overestimate global horizontal irradiance (GHI). The assimilation of cloud water path (CWP) retrievals from geostationary satellites using an ensemble Kalman filter (EnKF) led to improved short-term GHI forecasts of the Weather Research and Forecasting (WRF) model in midlatitudes in case studies. An evaluation of the method under tropical conditions and a quantification of this improvement for study periods of more than a few days are still missing. This paper focuses on the assimilation of CWP retrievals in three phases (ice, supercooled, and liquid) in a 6-hourly cycling procedure and on the impact of this method on short-term forecasts of GHI for Réunion Island, a tropical island in the southwest Indian Ocean. The multilayer gridded cloud properties of NASA Langley's Satellite ClOud and Radiation Property retrieval System (SatCORPS) are assimilated using the EnKF of the Data Assimilation Research Testbed (DART) Manhattan release (revision 12002) and the advanced research WRF (ARW) v3.9.1.1. The ability of the method to improve cloud analyses and GHI forecasts is demonstrated, and a comparison using independent radiosoundings shows a reduction of specific humidity bias in the WRF analyses, especially in the low and middle troposphere. Ground-based GHI observations at 12 sites on Réunion Island are used to quantify the impact of CWP DA. Over a total of 44 d during austral summertime, when averaged over all sites, CWP data assimilation has a positive impact on GHI forecasts for all lead times between 5 and 14 h. Root mean square error and mean absolute error are reduced by 4 % and 3 %, respectively.
In the case of infinite plane-parallel single- and double-layered cloud, the solar irradiance at ground level computed by a radiative transfer model can be approximated by the product of the irradiance under clear atmosphere and a modification factor due to cloud properties and ground albedo only. Changes in clear-atmosphere properties have negligible effect on the latter so that both terms can be calculated independently. The error made in using this approximation depends mostly on the solar zenith angle, the ground albedo and the cloud optical depth. In most cases, the maximum errors (95th percentile) on global and direct surface irradiances are less than 15 W m−2 and less than 2–5% in relative value. These values are similar to those recommended by the World Meteorological Organization for high-quality measurements of the solar irradiance. Practically, the results mean that a model for fast calculation of surface solar irradiance may be separated into two distinct and independent models, possibly abacus-based, whose input parameters and resolutions can be different, and whose creation requires less computation time and resources than a single model.
1 January 2024 in Histoire de la recherche contemporaine
Actuellement, la production d’énergie représente environ 35 % des émissions de gaz à effet de serre. Respecter l’accord de Paris nécessite d’avoir d’ici 2100, 90 % d’énergies décarbonées dans la consommation d’énergie primaire. Pour atteindre ces objectifs ambitieux, il est impératif d’électrifier certains usages tels que le chauffage et la mobilité. Cela implique une transformation rapide de la production énergétique actuelle, majoritairement basée sur les combustibles fossiles, vers des technologies à faible émission de carbone. Parmi ces technologies, les énergies renouvelables occupent une place centrale. Intégrer à des fins de prospective les scénarios de changements climatiques et socio-économiques pour définir les mix électriques optimaux est un des axes de recherche du LMD (Laboratoire de météorologie dynamique) depuis la fin des années 2010. À des horizons temporels plus courts, le LMD explore des solutions favorisant l’intégration des énergies renouvelables variables dans le réseau électrique, notamment la cartographie des ressources avant l’installation de dispositifs de production et les prévisions du potentiel solaire et éolien afin de mieux gérer l’équilibre entre l’offre et la demande. Ces solutions font naturellement appel à l’expertise développée au LMD et sont cruciales pour la décarbonation du secteur de l’énergie.